Figure 113 Menu 12.3: Bridge Static Route Setup; Figure 114 Menu 12.3.1: Edit Bridge Static Route; Table 70 Menu 12.3.1: Edit Bridge Static Route - ZyXEL Communications P-791R V2 - V3.40 User Manual

Figure 113 Menu 12.3: Bridge Static Route Setup

Now, enter the index number of the static route that you want to configure.

Figure 114 Menu 12.3.1: Edit Bridge Static Route

The following table describes the fields in this screen.

Table 70 Menu 12.3.1: Edit Bridge Static Route

FIELD
Route #
Route Name
Active
Ether Address
IP Address
Gateway Node
Once you have completed filling in this menu, press [ENTER] at the message "Press ENTER to
Confirm..." to save your configuration, or press [ESC] to cancel.
P-791R v2 User's Guide
Menu 12.3 - Bridge Static Route Setup
1. ________
2. ________
3. ________
4. ________
Menu 12.3.1 - Edit Bridge Static Route
Route #: 1
Route Name= ?
Active= No
Ether Address= ?
IP Address=
Gateway Node= 1
DESCRIPTION
This is the index number of the static route that you chose in menu 12.
Enter a descriptive name for this route. This is for identification purposes only.
This field allows you to activate/deactivate this static route.
This parameter specifies the MAC address of the final destination.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
ZyXEL Device that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your ZyXEL Device; over the
WAN, the gateway must be the IP address of one of the remote nodes.
Press [SPACE BAR] and then [ENTER] to select the number of the remote node
that is the gateway for this static route.
Chapter 23 Static Route Setup
197