Table of Contents
Advertisement
Chapter 4 Wireless Configuration
Table 8 Security Setting: WEP (continued)
LABEL
Back
Next
Exit
4.3.1.2 WPA-PSK/WPA2-PSK
Figure 30 Security Setting: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 9 Security Setting: WPA-PSK/WPA2-PSK
LABEL
Encryption Type
Pre-Shared Key
Back
Next
Exit
4.3.1.3 WPA/WPA2
The screen that displays when you select WPA or WPA2 differs, depending on the EAP Type
you select (TLS, PEAP or TTLS).
The procedure to configure WPA or WPA2 is different in Windows Vista. See
Section 4.6 on page 64
WPA or WPA2 in Vista.
52
DESCRIPTION
Click Back to go to the Site Survey screen to select and connect to another
network.
Click Next to confirm your selections and advance to the Summary screen. Refer
to
Section 4.3.3 on page
55.
Click Exit to return to the Site Survey screen without saving.
DESCRIPTION
The encryption mechanisms used for WPA/WPA2 and WPA-PSK/WPA2-PSK are
the same. The only difference between the two is that WPA-PSK/WPA2-PSK uses
a simple common password, instead of user-specific credentials.
Select the encryption type (TKIP or AES) for data encryption.
Refer to
Section 3.2.1.3 on page 39
Type a pre-shared key (same as the AP or peer device) of between 8 and 63
case-sensitive ASCII characters (including spaces and symbols) or 64
hexadecimal characters.
Click Back to go to the Site Survey screen to select and connect to another
network.
Click Next to confirm your selections and advance to the Summary screen. Refer
to
Section 4.3.3 on page
55.
Click Exit to return to the Site Survey screen without saving.
for information on setting up your NWD210N to use
for more information.
NWD210N User's Guide
Advertisement
Table of Contents
Troubleshooting
