Figure 25 Basic Setting > General Setup; Table 10 Basic Setting > General Setup - ZyXEL Communications GS-2750 User Manual

Chapter 7 Basic Setting
Figure 25 Basic Setting > General Setup
The following table describes the labels in this screen.
Table 10 Basic Setting > General Setup
LABEL
System Name
Location
Contact Person's
Name
Use Time Server
when Bootup
Time Server IP
Address
Current Time
New Time
(hh:min:ss)
Current Date
74
DESCRIPTION
Type a descriptive name for identification purposes. This name consists of up to 64
printable characters; spaces are allowed.
Type the geographic location of your Switch. You can use up to 32 printable ASCII
characters; spaces are allowed.
Type the name of the person in charge of this Switch. You can use up to 32
printable ASCII characters; spaces are allowed.
Type the time service protocol that your timeserver uses. Not all time servers
support all protocols, so you may have to use trial and error to find a protocol that
works. The main differences between them are the time format.
When you select the Daytime (RFC 867) format, the Switch displays the day,
month, year and time with no time zone adjustment. When you use this format, it is
recommended that you use a Daytime timeserver within your geographical time
zone.
Time (RFC-868) format displays a 4-byte integer giving the total number of
seconds since 1970/1/1 at 0:0:0.
NTP (RFC-1305) is similar to Time (RFC-868).
None is the default value. Enter the time manually. Each time you turn on the
Switch, the time and date will be reset to 1970-1-1 0:0.
Type the IP address of your timeserver. The Switch searches for the timeserver for
up to 60 seconds. If you select a timeserver that is unreachable, then this screen
will appear locked for 60 seconds. Please wait.
This field displays the time you open this menu (or refresh the menu).
Enter the new time in hour, minute and second format. The new time then appears
in the Current Time field after you click Apply.
This field displays the date you open this menu.
GS-2750 User's Guide