Remote Control; Before Operation; Inserting Batteries; To Turn The Power On - Aiwa NSX-A909 Operating Instructions Manual

Inserting batteries
Detach tie battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
DISPLAY—
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
. The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
lLmm&-.=
-tlH-
DEMO
CD
To
turn the power on
Press one of the function buttons
(TAPE, TUNER, VIDEO/AUX,
CD, MD).
Playback of the inserted disc or tape begins, or the
previously tuned station is received (Direct Play Function),
POWER
is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.
To
turn the power
off
Press
POWER.
Flash windows
The windows on the top of the unit and the cassette decks light
up or flash while the unit is being powered on.
To turn off the light of the top window, press while pressing
CD. To turn back on, repeat the above.
The light of the cassette decks cannot be turned off.
To dim the illumination of the display
1
Press
DISPLAY
twice so that "DIMMER" is displayed.
2 Within 4 seconds, turn
MULTI JOG
to select the dimmer mode
as follows.
~DIMMERO~DIMMER 1 *DIMMER 2++ DIMMER 3~
I I
DIMMER O:
The normal display.
DIMMER 1:
The illumination of the display is dimmer than
usual.
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3:
The illumination of the display is dimmer than
DIMMER 2, and the spectrum analyzer and the illumination
on the buttons light off.
5
ENGLISH