Remote Control; Before Operation - Aiwa Z-L120 Operating Instructions Manual

REMOTE CONTROL

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
To use SHIFT on the remote control
Buttons 1 have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing SHIFT.
To use FUNCTION on the remote control
FUNCTION substitutes for the function buttons (TAPE, TUNER/
BAND, VIDEO/AUX/PHONO, CD) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically.
1
SHIFT
NOTE
• If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight.
- Other remote controls are used nearby (those of a television,
etc.).
R6 (AA)
FUNCTION

BEFORE OPERATION

s
a
POWER
6 STANDBY/ON
f,g
To turn the unit on
Press one of the function buttons (TAPE, TUNER/BAND, VIDEO/
AUX/PHONO, CD). Playback of the inserted disc begins, or the
previously tuned station is received (Direct Play Function).
POWER 6 STANDBY/ON is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.
To turn the unit off
Press POWER 6 STANDBY/ON.
DEMO (Demonstration) mode
When the AC cord is connected, the display window demonstrates
the functions of the unit. When the power is turned on, the DEMO
display is overridden by the operation display. When the power is
turned off, the DEMO mode is restored.
When the clock is set, the DEMO will not begin even if the power
is turned off.
To deactivate or activate DEMO
Press ECO/DEMO when the unit is turned off.
To change the brightness level of the display
1 When the unit is turned on, press ECO/DEMO twice so that
"DIM MODE" is displayed.
2 Within 4 seconds, press a a a a . a
3 Within 4 seconds, press f f or g f f
f
dimmer mode as below.
DIM-OFF DIMMER 1
"DIM-OFF" mode is the brightest and "DIMMER 3" mode is
the dimmest.
4 Within 4 seconds, press a to set the selected mode.
ECO/DEMO
TAPE, TUNER/BAND,
VIDEO/AUX/PHONO,CD
g repeatedly to select the g g
g
DIMMER 2 DIMMER 3
4
ENGLISH
En