Advertisement
Available languages
Available languages
1
2
3
The clock is displayed,
(The ":" between the hours and minutes
flashes.)
When the power cord is plugged
into an AC outlet
for the first time after purchase
or when the clock setting
is
canceled
due to a power
failure,
the entire
clock
display
flashes.
Press CLOCK.
When using the remote control, press
CLOCK
while pressing
SHIFT.
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning
MULTI JOG
changes
both the hour and the minute.
+
or >
is also available
instead of
MULTI JOG.
Holding
these buttons down will vary the time rapidly.
Press ENTER or Il.
The clock starts from 00 seconds.
To
restore an original clock setting
Press
CLOCK
before completing
step 3 to restore the previous
time setting. This cancels
any new setting.
To view the clock when another display is in the display
Press CLOCK.
The time is displayed
for 4 seconds
and then the
original
display
reappears.
However,
the clock
cannot
be
displayed
during recording.
To
switch to the 24-hour standard
Press the
CLOCK
and then press
within 4 seconds.
Repeat t~f2 same procedure
10
restore the 12-IIOLN
StandEKL
~
This is caused by a power interruption.
The current time needs
If power is interrupted
for more than approximately
24 hours,
all settings stored in memory after purchase
need to be reset.
J
The unit can be turned off automatically
at a specified
time.
Use the remote control.
1 Press SLEEP while pressing SHIFT.
2 Within 4 seconds, turn MULTI JOG to specify the
time until the power is turned off.
The time changes
between
5 and 240 minutes
in 5-minute
steps.
++
and
> are also available
instead of
MULTI JOG.
Specified
time
While the timer is in operation,
the display
indication
is dimmer
than usual.
To
check the time remaining until the
power is turned off
Press
SLEEP
once while pressing
SHIFT. The remaining
time is
displayed
for 4 seconds.
To cancel the sleep timer
Press
SLEEP
twice while pressing
SHIFT so
that "SLEEP
oFF
appears
on the display.
If the power-economizing
mode (page 7) is on, all the display
lights turn off when the power is turned
off. To view the clock,
press
CLOCK so
that the time is displayed
for 4 seconds.
.-
~b
ENGLISH
Advertisement
