Pandora Marine Wiring Diagram

WARNING!
information in Pandora Specialist app
and on specialist.alarmtrade.ru; update
installation; choose the
code if the CAN-bus connected.
BASE UNIT
PLACEMENT
WARNING!
Keep minimum distance of 20 mm between
the system and metal parts.
WARNING! Fixate the protective cap using
LED VALET m c i o r U B S
WARNING! The backup battery is charged
automatically when the engine is running.
The system uses the backup battery only
Li-Po accu
XP1
in security mode.
3.7V 330mAh
XP2
GSM/LTE (4G/3G/2G)
Antenna GNSS
(GPS/GLONASS)
WARNING!
Disarm the system
and disconnect
the power supply
before installing/
replacing
nano-SIM
a SIM-card.
Before installation: check the WARNING! The installation locations of the
base unit and system elements must meet
their temperature, dust- and moisture-
protection characteristics. The base unit
model is designed to operate at temperatures from
-40°C to +60°C, the degree of protection
is IP54.
Do not shield the built-in antennas.
16
15
14
13
12
11
10
9
8 16
8
7 15
7
6 14
6
5 13
5
4 12
4
3 11
3
2 10
2
1 9
1
WARNING! The system is a maintenance-
free device. In case of failure you must
immediately contact your local supplier.
Black
Orange/White
Orange/Black
Engine temperature sensor*
White
Blue/Black
External VALET button*
Red/Black
(+)
INP1 – "Ignition" input
Yellow
(+)
INP3 – "
Blue/White
Red POWER SUPPLY (+12V)
500 mA (+ 12V)
Pink CH7 – " ights" output
500 mA (+12V)
Pink CH6 – " ights" output
500 mA (+12V)
CH5 – "Siren/Beeper" output
Purple
200 mA (—)
INP2/CH4 – "Blocking 1 NC" output
Green
200 m A (—)
CH3/INP6 – "Trunk" input
Blue
200 mA (—)
Brown/White CH2/INP5 – "Trunk" input
200 mA (—)
Grey CH1/INP4 –
Pandora Marine
WIRING DIAGRAM
WARNING! All power circuits of additional IT IS FORBIDDEN
devices that are not powered through the system on a
base unit of the system should have their voltage other than 12V.
own fuses. IT IS FORBIDDEN
bypass original fuses of a system
in the installation process.
IT IS FORBIDDEN
system with damaged output
cables.
IT IS FORBIDDEN
CAN-H
temperature sensor at the place
where temperature is higher than
the operating range of the sensor
CAN-L
(+125°C) and cable (+80°C).
IP40
input
86
87a
30
85
+12V
input
trigger
to install the
with normal
to change or
to install the
to install the
*Cut the connector
when connecting
external tempera-
ture sensor
or VALET button
IP65
IP54
Green/Black NC
Green/Red COM
NО
Green
to original wiring
v 1.0