Garmin inReach EXPLORER + Instruction Manual page 4

a few minutes to complete. If you do not see the "Test Successful" screen after 15 minutes,
switch to another location with a clearer view of the sky.
a. Note: The LED may blink red while testing. If so, don't worry. As long as the arrow at
the top of the screen doesn't have continuously a question mark over it and as long as
the twin arrows blink on the top of the screen, everything's fine.
4. After you see the "Test Successful" screen, press the select key to return to the main menu
To sync the device with your iPhone:
1. On the device, navigate
to "Settings" on the
main menu, then press
the select key
2. Select "Bluetooth"
3. Make sure "Enabled" is
"On"
4. The menu may show
"Connected" as "Yes"
or "No," depending on
whether the device is
currently paired with a
phone. Assuming you
want to connect it with
your phone, you will
need to disconnect it.
To do so, select "Pair
Device"
5. If the previous screen
showed "Connected" as
"Yes," you will see a
warning saying that
the device is already
paired. If so, select
"Pair Again." You will
see a prompt telling
you to follow the
instructions on your
mobile device
6. On your iPhone, go to
"Settings"
7. Select "Bluetooth"
8. Make sure Bluetooth is
turned on, then find
the "inReach
________" device. The
8-digit device identifier
will match the number on the inReach device
9. After the device shows up as "Connected," confirm by opening the
"Earthmate" app and selecting "My inReach." If you succeeded, the device
will show up as connected.