Related Manuals for SONICTONE AMPLIFICATION SE Series
Summary of Contents for SONICTONE AMPLIFICATION SE Series
- Page 1 SE Series 6-Watt or 12-Watt Cathode-Biased Single-Ended Class A Tube Amplifier Head or 1x12 Combo Owner’s Manual www.sonictoneamps.com Made in the USA...
-
Page 2: Table Of Contents
Table of Contents Introduction ............... Safety Instructions ............Features ................Front Panel ................. Rear Panel ................Warranty ................Sample Settings ............... Specifications ..............SonicTone Amplification, LLC P.O. Box 24456 New Orleans, LA 70184 contact@sonictoneamps.com www.sonictoneamps.com Made in the USA... -
Page 3: Introduction
Introduction The SE series of SonicTone amplifiers is a special, limited run series of amps. What’s so special about it? Well, if you know, you know. This series is for the true tube amp aficionados out there. The amplifiers in the SE series are simple, pure single-ended class A designs. They are low-wattage circuits that allow you to fully drive the amp, achieving that sweet even-order harmonic saturation and tone for which single-ended class A amps are known. -
Page 4: Safety Instructions
Safety Instructions Always use the correct types of tubes for this amplifier. Please only use a TRS cable to connect the footswitch to the amplifier. Always match the impedance to correct value of the speaker load. Please operate the amplifier in dry and safe conditions. Do not attempt to bypass the fuses or use different Please store the amplifier in a reasonable, climate- fuse values. -
Page 5: Front Panel
Front Panel Pilot Light – illuminates when the amp is turned on. Power Switch – turns the amp on. Standby Switch – allows the amp to be played. When the standby is off, the tubes are kept warm, but the amp will not make any sound. Bass, Middle and Treble –... -
Page 6: Rear Panel
Rear Panel WARNING! SE-6 Dangerous and potentially lethal voltages may be 12AX7 12AX7 12AX7 EL84 EZ81 present in the amplifier even after it has been turned off and unplugged. Only have a qualified service S / N : S E 0 0 0 0 0 0 0 0 0 0 0 0 C L A S S A A M P L I F I E R technician open up and work on the amplifier. -
Page 7: Warranty
2-Year Limited Warranty This amplifier is protected with a limited, 2-year warranty for any and all defective issues with the build workmanship and parts, excluding tubes, transformers and speakers. The warranty does not cover general wear and tear, neglect, misuse or abuse, damage from liquids (water, alcohol, etc.), disasters, acts of God or unauthorized modifications. -
Page 8: Sample Settings
Sample Settings Channel 1 - Sparkly Clean: Channel 1 - Blues Crunch: Channel 2 - Classic Rock: Channel 2 - Hard Rock:... -
Page 9: Specifications
Depth: 9 in Depth: 10 in Depth: 9 in Depth: 10 in Weight: 21.5 lbs Weight: 37.0 lbs Weight: 25.5 lbs Weight: 40.0 lbs www.sonictoneamps.com Made in the USA The SonicTone logo is a registered trademark of SonicTone Amplification, LLC.
Need help?
Do you have a question about the SE Series and is the answer not in the manual?
Questions and answers