SONICTONE AMPLIFICATION PATRIOT Owner's Manual

60-watt or 120-watt fixed-biased 4-channel high-gain tube amplifier head (mark ii)

Advertisement

Quick Links

Modern Series
60-Watt or 120-Watt
Fixed-Biased
4-Channel High-Gain
Tube Amplifier Head
(Mark II)
Owner's Manual
www.sonictoneamps.com
Made in the USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PATRIOT and is the answer not in the manual?

Questions and answers

Summary of Contents for SONICTONE AMPLIFICATION PATRIOT

  • Page 1 Modern Series 60-Watt or 120-Watt Fixed-Biased 4-Channel High-Gain Tube Amplifier Head (Mark II) Owner’s Manual www.sonictoneamps.com Made in the USA...
  • Page 2: Table Of Contents

    Table of Contents Introduction ............... Safety Instructions ............Features ................Front Panel ................. Rear Panel ................Warranty ................Sample Settings ............... Specifications ..............SonicTone Amplification, LLC P.O. Box 24456 New Orleans, LA 70184 contact@sonictoneamps.com www.sonictoneamps.com Made in the USA...
  • Page 3: Introduction

    Modern Series line up, the Patriot is an American-voiced 4-channel high gain machine. Carefully designed and hand-built here in the U.S., the Patriot is full of features and can produce blistering tones for the most demanding players. Whether playing live or in the studio, this amp will deliver for you.
  • Page 4: Features

    Features The Patriot is a fixed-biased, high-gain 4-channel tube amplifier that uses five (5) 12AX7 preamp tubes. The 60- watt model uses two (2) 6L6 power tubes and the 120-watt model users four (4) 6L6 power tubes. The features include:...
  • Page 5: Front Panel

    Front Panel Pilot Light – illuminates when the amp is Mid Cut/Boost Switch – switch to engage a mid-range turned on. cut or boost on channel 3. Power Switch – turns the amp on. Gain 3 – control to adjust the gain on channel 3. Standby Switch –...
  • Page 6: Rear Panel

    Rear Panel Footswitch Jack – 7-pin DIN jack to plug the provided footswitch cable into. FX Loop Send Jack – mono input jack for the send FX loop instrument level signal. FX Loop Bypass Switch – switch to fully bypass the FX loop circuit. FX Loop Return Jack –...
  • Page 7: Warranty

    Rear Panel (continued) Impedance Selector Switch – switch to select the correct impedance of the speaker load hooked up to the amp. Bias Probes – test jacks to check the approximate bias point of each power tube in millivolts (mV).* Full/Half Power Switch –...
  • Page 8: Sample Settings

    Sample Settings Channel 1: Chimey Clean Channel 1: Edge of Breakup Channel 2: Blues Crunch Channel 2: Classic Rock Channel 2: Hard Rock Channel 3: Modern Rock Channel 4: Heavy Metal...
  • Page 9: Specifications

    Width: 30 in Width: 30 in Height: 10.75 in Height: 10.75 in Depth: 9 in Depth: 9 in Weight: 35.0 lbs Weight: 42.5 lbs www.sonictoneamps.com Made in the USA The SonicTone logo is a registered trademark of SonicTone Amplification, LLC.

Table of Contents