Table of Contents
Advertisement
INSTALLATION
wind screen) and press the lever on the suction head downwards. The suction head
will stick itself firmly to the suction plate.
5. Place the navigation system into the car holder by placing it initially in the lower
noses and then pressing it down gently until the holder clicks in.
Connecting The Navigation System In The Car
When the battery is in a low voltage, you can recharge it in the car:
1. Plug the jack (1) of the connection cable into the corresponding receptor at the
bottom of your navigation system .
2. Insert the power adapter (2) now into the cigarette lighter socket and ensure, that
it will not lose contact while driving. This could cause a malfunction.
3. Hint: Remove the power adapter from the cigarette lighter socket when ending a
trip or when parking the car for a extended period of time. Otherwise the car
3. Fix the complete holding device with the supplied screw (5) and tighten it slightly
by hand.
4. Now insert the navigation system into the holder. You must pay attention to a firm
seating of the clip holder.
5. Set the inclination angle by screwing the bicycle holder in according to your
requirements. Now turn the screws finger-tight.
Holder
2
1
9
Advertisement
Table of Contents
