LENCO NAV-400 Owner's Manual page 8

INSTALLATION
of the navigation system. Only follow the instructions when circumstances and driving
rules permit it! The navigation system will guide you to your destination even when
you have to deviate from your planned route.
• The direction statements of the navigation system given do not release the driver
of the vehicle from his or her duty of care or personal responsibility.
• Plan routes before you leave. If you want to play a new route whilst on the road stop
driving.
• In order to receive the GPS signal correctly, metal objects may not hinder reception.
Attach the navigation system onto the inside of the windscreen or near the windscreen
with the sucker. Try out different positions in your vehicle in order to find the best
reception.
Notes for Use In A Vehicle
• Take care that the holder does not present any risk to safety, even in the case of an
accident, when installing it.
• Take care that the cable does not impede any safety components.
• The display of your navigation system may show "light re-flexions". Please take care
of not being "blinded" during operation.
• Take care that the cable does not impede any safety components.
• Do not mount the components within the operating range of any airbags.
• Check the secure adherence of the suction cup at regular intervals.
• The power plug will consume power, even if no device is connected. Remove it when
not in use to avoid draining the battery.
• Check all safety equipment in your car after installation.
Additional Notes for Use on A Bicycle Or A Motorcycle
• Pay attention during installation that the ability to steer is not impaired.
• Do not cover any instruments during installation.
Mounting The Navigation Set In A Car
Attention! Only fix the holder for the navigation system to the windscreen, if it does
not impede the view. Should this not be possible, Then mount the holder with the
enclosed suction plate in any way that will allow peril-free and safe operation. Installation
Of The Holder Of The Navigation System
• Hint: If you want to fix the holder to the wind screen, then you can skip steps 1 and
2.
1.Remove the protective foil from the sticky side of the suction plate.
2.Fix the suction plate to a suitable location on the dashboard. Take care, that the
surface of the dashboard is clean and press the suction plate strongly onto the
surface.
• To obtain a strong and secure hold the suction plate should not be used for 24 hours.
3. Mount the car holder to the flexible neck. Note the labels on the flexible neck. The
arrow labelled CLOSE must point in the direction of the fixture. The connection
closes with a noticeable clicking sound.
4. Place the holder with the suction head onto the suction plate (or directly onto the
Suction
Car holder
Flexible neck
8
Suction