Important Safeguards and Warnings
Electrical Safety
All installation and operation should conform to your local electrical safety codes.
The power source shall conform to the Safety Extra Low Voltage (SELV) standard, and supply power with
rated voltage which conforms to Limited power Source requirement according to IEC60950-1. Please note
that the power supply requirement is subject to the device label.
Make sure the power supply is correct before operating the device.
A readily accessible disconnect device shall be incorporated in the building installation wiring.
Prevent the power cable from being trampled or pressed, especially the plug, power socket and the junction
extruded from the device.
Environment
Do not aim the device at strong light to focus, such as lamp light and sun light; otherwise, it might cause
over brightness or light marks, which are not the device malfunction, and affect the longevity of
Complementary Metal-Oxide Semiconductor (CMOS).
Do not place the device in a damp or dusty environment, extremely hot or cold temperatures, or the locations
with strong electromagnetic radiation or unstable lighting.
Keep the device away from any liquid to avoid damage to the internal components.
Keep the indoor device away from rain or damp to avoid fire or lightning.
Keep sound ventilation to avoid heat accumulation.
Transport, use and store the device within the range of allowed humidity and temperature.
Heavy stress, violent vibration or water splash are not allowed during transportation, storage and installation.
Pack the device with standard factory packaging or the equivalent material when transporting the device.
Install the device in the location where only the professional staff with relevant knowledge of safety guards
and warnings can access. The accidental injury might happen to the non-professionals who enter the
installation area when the device is operating normally.
Operation and Daily Maintenance
Do not touch the heat dissipation component of the device to avoid scald.
Carefully follow the instructions in the manual when performing any disassembly operation about the
device; otherwise, it might cause water leakage or poor image quality due to unprofessional disassemble.
Please contact after-sale service for desiccant replacement if there is condensed fog found on the lens
after unpacking or when the desiccant turns green. (Not all models are included with the desiccant).
It is recommended to use the device together with lightning arrester to improve lightning protection effect.
It is recommended to ground the device to enhance reliability.
Do not touch the image sensor (CMOS) directly. Dust and dirt could be removed with air blower, or you
can wipe the lens gently with soft cloth that moistened with alcohol.
Device body can be cleaned with soft dry cloth, which can also be used to remove stubborn stains when
moistened with mild detergent. To avoid possible damage on device body coating which could cause
performance decrease, do not use volatile solvent such as alcohol, benzene, diluent and so on to clean
the device body, nor can strong, abrasive detergent be used.
Dome cover is an optical component, do not touch or wipe the cover with your hands directly during
installation or operation. For removing dust, grease or fingerprints, wipe gently with moisten oil-free cotton
with diethyl or moisten soft cloth. You can also air blower to remove dust.
IV
Need help?
Do you have a question about the ORANGE CP-UNC-DA21L2-GP-2MP and is the answer not in the manual?