Advertisement
Quick Links
User'sGuide
Shop online at
omega.com
e-mail: info@omega.com
For latest product manuals:
www.omega.com
Above items are included with the DBCL130
Dry Block temperature calibrator. Not shown
is the calibration certificate and operator manual
Model DBCL130
Dry Block Temperature Calibrator
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Omega DBCL130
Summary of Contents for Omega DBCL130
- Page 1 User’sGuide Shop online at omega.com e-mail: info@omega.com For latest product manuals: www.omega.com Above items are included with the DBCL130 Dry Block temperature calibrator. Not shown is the calibration certificate and operator manual Model DBCL130 Dry Block Temperature Calibrator...
- Page 2 DBCL130 Dry Block Temperature Calibrator Introduction The DBCL130 calibrator provides a safe, dry, constant temperature source for checking and calibrating a wide range of temperature sensors, systems, indicators and thermometers. It is fast and economical and can be used either on a bench top or as a portable field unit. The weight of the unit is only 15 pounds/6.8 kilograms.
- Page 3 240V UK 5 AMP The fuse in the unit protects the unit and the operator. Note that the model DBCL130 operates on any mains voltage from 100 to 240VAC. However a properly rated mains cable should be used based on the mains operating voltage used.
- Page 4 P a g e OPERATION Preparation The heater design, temperature sensor and control circuit give good temperature control and uniformity, but make sure that there is a close fit of the probes in the block to allow efficient heat transfer. Contact us about an insert that more closely fits your probe or device being calibrated.
- Page 5 Please include any details of the fault observed and remember to return the unit in its original packing. Omega Engineering will accept no responsibility for any damage to units that are improperly packed for shipment. If in doubt, contact your supplier.
- Page 6 P a g e Accessories The following parts may be obtained from Omega Engineering if replacements or alternatives are required: Part Number Description UK 240 volt power cable with 13amp UK plug (5 amp fuse) DBCL-UKCABLE 4164 Euro style 240 volt power cable with R/A Schuko plug...
- Page 7 Dry Block Temperature Calibrator Specification Model DBCL400 operating range ambient +5 to 450°C Model DBCL130 operating range -25 to 130°C (20°C ambient) 5. The object of the declaration described above is in conformity with the relevant Union harmonisation legislation: 2014/35/EU...
- Page 8 Fax: (203) 359-7700 e-mail: info@omega.com For Other Locations Visit omega.com/worldwide The information contained in this document is believed to be correct, but OMEGA accepts no liability for any errors it contains, and reserves the right to alter specifications without notice.
- Page 9 Department will issue an Authorized Return (AR) number immediately upon phone or written request. Upon examination by OMEGA, if the unit is found to be defective, it will be repaired or replaced at no charge. OMEGA’s WARRANTY does not apply to defects resulting from any action of the purchaser, including but not limited to mishandling, improper interfacing, operation outside of design limits, improper repair, or unauthorized modification.
- Page 10 Where Do I Find Everything I Need for Process Measurement and Control? OMEGA…Of Course! Shop online at omega.com TEMPERATURE M U Thermocouple, RTD & Thermistor Probes, Connectors, Panels & Assemblies M U Wire: Thermocouple, RTD & Thermistor M U Calibrators & Ice Point References M U Recorders, Controllers &...
Need help?
Do you have a question about the DBCL130 and is the answer not in the manual?
Questions and answers