Advertisement
Chapter 4
Tips:
• If you use
Dynamic IP
and
please go to
Advanced
>
• If you still cannot access the internet, refer to the
4. 4.
Set Up the Router as an Access Point
The router can work as an access point, transforming your existing wired network to a
wireless one.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to
Advanced
>
SAVE. The router will reboot and switch to Access Point mode.
3. After rebooting, connect the router to your existing wired router via an Ethernet cable.
4. Log in again to the web management page http://tplinkwifi.net, and go to
>
Quick
Setup.
5. Configure your wireless settings and click NEXT.
6. Confirm the information and click SAVE. Now, you can enjoy Wi-Fi.
Tips:
• Functions, such as Parental Controls, QoS and NAT Forwarding, are not supported in the Access Point mode.
• Functions, such as Guest Network, are the same as those in the Router mode.
PPPoE
and you are provided with any other parameters that are not required on the page,
Network
>
Internet
to complete the configuration.
FAQ
System
>
Operation
section for further instructions.
Mode, select
Access Point Mode
Set Up Internet Connection
and click
Advanced
18
Advertisement
Need help?
Do you have a question about the BE7200 and is the answer not in the manual?