Tech Controllers EU-M-12t User Manual page 21

➢ CH set point temperature – the function is used to set the CH set point temperature, after which the reheating will
turn off.
➢ DHW settings
•
Operation mode - a function that allows you to select the mode from schedule, time mode and constant
mode. If the constant or time mode is:
- Active – DHW setpoint temperature applies
- Inactive – lower temperature applies.
•
Setpoint temperature – this option allows you to set the DHW setpoint temperature, after which the pump
will turn off (applies if the
•
Lower temperature - an option that allows you to set the DHW pre-set temperature that will be valid if the
Inactive mode is selected.
•
Schedule settings - a function that allows you to set the schedule, i.e. the time and days on which the
specified DHW pre-set temperature will apply.
7.10. LANGUAGE
This function allows you to change the controller language version.
7.11. REPEATER FUNCTION
In order to use the repeater function:
➢
Select registration
➢
Start the registration on the transmitting device
➢
After the correct execution of steps 1 and 2, the wait prompt on the ML-12 controller should change from
"Registration step 1" to "Registration step 2", and 'successful communication' will be displayed on the transmitting
device.
➢
Run the registration on the target device or on another device that supports repeater functions.
The user will be notified by an appropriate prompt about the positive or negative result of the registration process.
CAUTION
Registration must always be successful on both registered devices.
7.12. FACTORY SETTINGS
This function allows you to return to the Fitter's menu settings saved by the manufacturer.
8. SERVICE MENU
The controller service menu is only available to authorized persons and is protected by a proprietary code held by Tech
Sterowniki.
9. FACTORY SETTINGS
This function allows you to return to the menu settings saved by the manufacturer.
Active mode is selected)
Menu → Fitter's menu → Repeater function → Registration
21