Airzone Aidoo Pro AZAI6WSPPA2 Quick Manual page 5

Aidoo Pro Control Wi-Fi by Airzone
FUNCTIONS
Aidoo Pro Air To Water is a solution for the remote control and integration of air to water
units via Cloud services. This device makes it possible to manage the production, control the
temperature and program air to water units.
Aidoo Pro Air To Water communicates with the AC unit using the manufacturer's original
protocol. Therefore, the functions of each device may be different depending on the model. The
main functions of the Aidoo Pro Air To Water device are:
Unit control and error detection. The control options depend on the manufacturer's protocol
and how the unit is configured. The following parameters can be configured:
•
Status of up to two water circuits, if permitted by the manufacturer's unit.
•
Domestic hot water (DHW) status.
•
Operation mode.
•
Working settings.
•
Set-point temperature.
•
Room temperature reading.
Note: for further information on your Aidoo Pro Air To Water device, refer to the "Control
options" section.
Digital input (configurable from Airtools on Airzone Cloud). The digital input enables the
remote on/off control of the unit depending on the accessory used, which can be configured
as open window detection or as occupancy detection. By default, it will be disabled and
configured as "normally open".
Auto Mode (configurable from Airtools on Airzone Cloud). Auto mode enables the automatic
change of the operation mode.
Simulation Mode (configurable from Airtools on Airzone Cloud). Simulation Mode allows the
Aidoo Pro to be used from Airtools on Airzone Cloud even when it is not connected to an indoor
unit.
Gateway function (configurable from Airtools on Airzone Cloud). The device can be configured
to function as an air to water gateway, allowing an individual indoor unit to be integrated into
an Airzone zoned system.
Set-point temperature. Two set-point temperatures can be set.
Temperature limits (configurable from Airtools on Airzone Cloud). The maximum temperature
can be set in heating mode, and the minimum temperature in cooling mode.
EN
5