Cd-Rom Installation - Tech Source RAPTOR DL-LITE - DRIVERS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

Raptor DL-Lite Drivers for Solaris Installation and Reference Manual
3.3

CD-ROM Installation

The following are step-by-step instructions for installing the
Raptor DL-Lite Drivers for Solaris Software from a CD-ROM.
1. Install a Raptor card in the computer as described in
Chapter 2.
2. Boot the computer with the -r (reconfiguration) option.
To do this on an UltraSPARC workstation, perform the
following steps:
•
Power ON the computer.
•
Wait until you see boot messages displaying on the
screen, then press and hold the Stop (L1) key, and
then press the A key.
•
At the ok prompt, type boot –r.
After the system comes up, log in as root.
3.
4. Insert the CD-ROM labeled "Raptor OpenWindows for
Solaris Software" into the drive.
5. If
/cdrom/cdrom0
automatically mounted. Change directories to the CD-
ROM by typing the following:
prompt# cd /cdrom/cdrom0
If /cdrom/cdrom0 does not exist, mount the CD-ROM
by typing the following:
exists, the CD-ROM
3-2
was