Changing Resolution And Bit-Depth; Dltconfig Utility - Tech Source RAPTOR DL-LITE - DRIVERS FOR SOLARIS INSTALLATION-REFERENCE Installation And Reference Manual

Raptor DL-Lite Drivers for Solaris Installation and Reference Manual

3.4 Changing Resolution and Bit-Depth

After installation you will need to configure the OpenWindows
screen resolution, bit-depth, and refresh rate for your monitor.
(This resolution is different from the console resolution.
Appendix A discusses the console resolution.) The resolution of
the Raptor DL-Lite card is fixed at 2560x1600 at 60 Hz.
However, at any time after installation you can change the other
parameters by using the dltconfig utility.
NOTE: You must be logged in as root to execute this
program.

3.4.1 dltconfig Utility

The dltconfig utility has an interactive menu-style interface
(See Figure 3.1). It can be used to set bit-depth and refresh
rate. To use this program to configure your Raptor card, type:
prompt# dltconfig
NOTE: If X Windows is running on the Raptor card(s) to be
configured, please exit out of it before running dltconfig.
Failure to do so could result in a corrupted screen for the
remainder of the X Window session.
3-4