Table of Contents
Advertisement
SOFTWARE INSTALLATION
3.1 Requirements
The following are prerequisites for installing the Raptor DL-Lite
Drivers for HP-UX software:
•
The workstation/server is running HP-UX 10.20, HP-UX 11.0 or
HP-UX 11i
•
Any previous versions of Raptor software have already been
uninstalled.
•
At least 5MB of disk space available in /usr for drivers.
•
A Raptor card is presently installed in the workstation/server
(See Chapter 2 for installing a Raptor graphics card).
The kernel will be rebuilt during installation.
3.2 CD-ROM Installation
The installation for each version of the HP-UX operating system is
discussed separately in the following sections.
3.2.1 Installation on HP-UX 10.20
The following are step-by-step instructions for installing the Raptor
Drivers for HP-UX 10.20 software from a CD-ROM.
1. Install a supported Raptor card in the HP workstation/server,
and boot the system.
2. Log in as root on the target system, using /sbin/sh as your
shell.
3. Uninstall any previous version of Raptor software in accordance
Chapter 3
3-1
Advertisement
Table of Contents
Need help?
Do you have a question about the RAPTOR DL-LITE - DRIVERS FOR HP-UX INSTALLATION-REFERENCE and is the answer not in the manual?