NESPRESSO AEROCCINO 3 Manual

Also See for AEROCCINO 3:

Manual (132 pages)

Instructions manual (81 pages)

Instruction manual (31 pages)

Table of Contents

Contents

1 INSTRUCTIONS OF USE
2 CLEAN DIRECTLY AFTER EVERY USE
3 TROUBLESHOOTING
4 SPECIFICATIONS
5 IMPORTANT SAFEGUARDS
6 Documents / Resources
- 6.1 References
- 6.2 Download manual

NESPRESSO AEROCCINO 3 Manual

INSTRUCTIONS OF USE

Risk of electrical shock and fire! Make sure the under side of the milk frother is dry.

information Tips: For optimal milk froth use semi skimmed, refrigerated (4-6°C / 39.2-42.8°F) milk. Milk which has been frozen will not froth. For hygiene and machine maintenance reasons: only use freshly opened, refrigerated, heat treated milk (pasteurised or UHT); do not use enriched milks, reconstituted powdered milks or flavoured milks; do not add syrups, sugar, chocolate powder or other substances into the jug. These can damage the coating during use. You can use soy, almond or oat drink for your preparations. Warning: Plant-based beverages contain allergens (soy, almond, gluten) and should be handled carefully by persons suffering from food allergies. The volume of froth depends on the nature of the beverage used, and its temperature.

Overview:
1. Lid
  a1. Seal
2. Start/stop Button
3. Milk frother
4. Mixer (for hot milk)
5. Frothing spring (for milk froth)
6. Base.
Clean before the first use. Attach the relevant whisk.
Ž Fill milk frother up to one of the two «max» level.
Place the lid on the Aeroccino. For a hot preparation, briefly press button to start. Button lights up Red. Take approx. 70-80 sec. For cold milk froth, keep button pressed for approx. 2 seconds. Button lights up Blue. Takes approx. 60 sec.

To ensure hygienic conditions and proper maintenance of the equipment, it is highly recommended to not use special enriched milks, powdered reconstituted milks nor flavored milks.
Syrup, sugar, chocolate powder or any other additives should not be added directly in the Aeroccino. This may damage the coating during the preparation.
Use only a non-metal spoon to collect the foam in the Aeroccino.

CLEAN DIRECTLY AFTER EVERY USE

Remove the Aeroccino from the base. Remove seal from lid. Remove the whisk, and the spring from the whisk.
Wash inner Aeroccino, seal, lid, whisk and spring with detergent and rinse with warm/hot water.
Do not put the Aeroccino in the dishwasher and do not immerse into water for cleaning purposes. Do not water the bottom part of the Aeroccino which contains the electrical plug, but clean the interior of the Aeroccino with detergent and rinse with warm/hot water. Use non-abrasive cleaning materials.
Dry all Aeroccino parts with a fresh and clean towel, cloth or paper and reassemble all parts.

Ensure the Aeroccino is cold before removing it from the base. Or, if removing with care, rinse with cold water immediately to cool down the Aeroccino and avoid burning risks.
Do not immerse neither the Aeroccino nor the base in the water.
In case the base needs to be cleaned, unplug it first and use only a damp cloth. Make sure the connector is dry before operation. Do not immerse the base in water nor put it in the dishwasher.
If the bottom part of the Aeroccino is wet, dry it before putting it back in contact with the base connector.
Only use non-abrasive cleaning materials. Do not use abrasives, sharp objects, brushes: risk of scratches and harm to the Aeroccino coating.

TROUBLESHOOTING

Aeroccino does not start	Be sure to position the jug correctly on a clean base. Be sure to attach the whisk to the jug correctly
Quality of milk froth not up to standard	Be sure to use whole or semi-skimmed milk at refrigerated temperature (39-43 F) Be sure to use the appropriate whisk and the jug is clean
Red Button blinking	The appliance is too hot. Rinse it under cool water Whisk is missing Not enough milk. Fill milk frother up to one of the two «max» level
Milk Overflows	Be sure to use the appropriate whisk and check the corresponding indicator level

SPECIFICATIONS

3597

USA/CA: 120V, 60Hz, 450W
AR: 220V, 50Hz, 410W
AUS: 220-240V, 50-60Hz, 380-450W
BR/MX: 127V, 60Hz, 505W
BR/CL: 220V-240V, 50-60Hz, 410-490W

IMPORTANT SAFEGUARDS

warning The instructions are part of the appliance. Read and follow all instructions to avoid possible harm and damage. Save these instructions and pass them on to any subsequent owner.

READ ALL INSTRUCTIONS

Avoid risk of fatal electrical shock and fire

Only plug the base into a suitable, earthed power socket. Make sure that the voltage of the power source is the same as that specified on the rating plate.
Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.

Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any control to «off», then remove plug from wall outlet.
To disconnect the appliance, stop any preparation, then remove plug from power socket.
Do not pull the cable over sharp edges, clamp it or allow it to hang down. Keep the cable away from heat and moisture.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons.
Disconnect the base from the power socket, when not in use for long periods. Disconnect by pulling out the plug and not pulling the cable itself, as this may damage the cable.
Never immerse the base nor the Aeroccino in water or other liquids. Do not clean in dishwasher. Electricity and water together can cause a fatal electric shock.
The connector must be removed before the appliance is cleaned, and ensure that the inlet is dried before the appliance is used again.
The appliance is only to be used with the base provided.
The appliance must not be immersed in water or any other liquids.
Short power-supply cords reduce risks resulting from becoming entangled in or tripping over a long cord.
Longer (or detachable) cords may be used if care is exercised in their use, and:
1. the marked electrical rating is at least as great as the electrical rating of the appliance
2. a grounding-type 3- wire cord is used
3. cord (s) is arranged so that it will not drape over the counter top or table top, where it can be pulled on or tripped over by anyone.
If an extension lead is required, use only an earthed cable with a conductor cross-section of at least 1.5 mm² /0.06 in² .

Avoid possible harm when operating the appliance

Never leave the appliance unattended during operation. Keep it out of the reach of children. The appliance is only for use by persons who have sufficient experience and knowledge and are physically, sensory, and mentally able to operate the machine safely in accordance with these instructions.
The appliance is intended to prepare beverages according to these instructions.
This is a household appliance only. It is not intended to be used in: staff kitchen areas in shops, offices and other working environments; farm houses; by clients in hotels, motels and other residential type environments; bed and breakfast type environments.
This appliance can be used by children 8 years old and older, as well as persons with reduced physical, sensory, mental capabilities or lack of experience, only if they have been given supervision and instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children under the age of 8 years old.
Do not use the appliance if damaged. A damaged appliance can cause electric shocks, burns and fire.
Do not touch hot surfaces. Use handles or knobs.
Do not operate any appliance with a damaged cord or plug in the appliance if it has malfunctioned, dropped or is damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair, or electrical or mechanical adjustment.
Children should be supervised to ensure that they do not play with the appliance.
Do not use outdoors.
Do not use the appliance for anything other than its intended use.
Scalding may occur if the lid is removed during the brewing cycles.
Extreme caution must be used when moving an appliance containing hot liquids.
Avoid contact with moving parts.
The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons.
The appliance is intended to prepare beverages according to these instructions. It is for use in private households. No liability is accepted for any other purposes, faulty operations or non professional repairs. Guaranteed services are also excluded in such cases.
Warning avoid spilling on the connector.
Heating element surface is subject to residual heat after use.
For perfect foam, use refrigerated UHT or pasteurized milk skimmed or semi-skimmed (approximately 4-6°C / 39.2-42.8°F).
You can use soy or almond or oat drink for your preparations. For people with lactose intolerance or milk allergy we would recommend having a separate device.
This equipment is not suitable for use with other products such as enriched milks, reconstituted powdered milks or flavoured milks.
To avoid hazards, never place the appliance on or beside hot surfaces, for example, radiators, stove tops, gas burners or similar.
Do not touch hot surfaces. Use handles or knobs.
To protect against fire, electric shock and injury to persons do not immerse cord, plugs or appliance in water or other liquid.
Please make sure the bottom of the Aeroccino and area underneath the base is dry, especially the connector area, prior to use. Electricity and water together risk a fatal electric shock.
If the Aeroccino is dropped, please do not use it. There is risk of water entering the electrical compartment through small cracks potentially generated by this incident.