Method Of Coping With Shift Lens Error (Hc7/Hc7E) - Sony Handycam HDR-HC5 Service Manual

1-7. METHOD OF COPING WITH SHIFT LENS ERROR (HC7/HC7E)

LD-221 BOARD (SIDE A)
Measurement points on the LD-221 board
Note: The length of low section will vary a little depending on the
conditions.
Change in output voltage of R5792 on the LD-221 board
1-7-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order
1 Turn the power OFF.
While measuring with an oscilloscope the output voltage of R5792 in the periphery of IC5703 on the LD-221 board, turn the
2
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
3
the camera control circuit (IC1801 of VC-500 board) periphery.
Note: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
HDR-HC5/HC5E/HC7/HC7E_L2
IC5703
Fig. 1
about 330 msec
Fig. 2
VC-500 BOARD (SIDE A)
R1823
R1823
Measurement points on the VC-500 board
Procedure
1-5
ENGLISH JAPANESE
ENGLISH JAPANESE
IC1801
Fig. 3