Caster And Leg Installation - Delfield 4400 series Installation & Operation Manual

Delfield
The 15-P plug shown in Figure 2 is used on the various
4400 Series models.
Figure 2. 5-15P Connector
Refer to the amperage data list in SPECIFICATIONS,
the serial tag, your local code or the National Electrical
Code to be sure the cabinet is connected to the proper
power source. A protected circuit of the correct voltage
and amperage must be run for connection of the line
cord, or permanent connection to the cabinet.
CAUTION
The thermostat must be turned to OFF and the cabinet
disconnected from the power source whenever per-
forming service, maintenance functions or cleaning the
refrigerated area.
10
Caster Mounting Detail
A universal bolt hole pattern, Figure 3, is provided on the
bottom of the cabinet. It will accommodate any caster.
Simply line up the plate holes with the corresponding
cabinet holes.
2.82"
If hole pattern on caster/leg
matches the one above,
mount in middle set of holes.
3" Caster - 3234024
5" Caster - 3234161
Figure 3. Universal Caster Mounting Pattern
Note:
For undercounter units, 2" casters will
be mounted into a recessed box.
2.14"
If hole pattern on caster/leg
matches the one above,
mount in inner set of holes.
2" Caster - 3234148