Setting The Self-Cleaning Mode; To Set The Self-Cleaning Mode; To Change The Cleaning Time; To Delay The Start Of Cleaning - Smeg SOU330X Use And Care Manual

To Set the Self-Clean Mode
1. Touch [UPPER/LOWER] key to select the
cavity to be cleaned, if the oven is a double.
2. Rotate both knobs into the clean position.
3. CLEAN & TIME appear.
4. The clean time is displayed automatically, its
standard value is 3 hours.
5. At the end of the programmed cleaning time,
the oven will automatically turn off.
6. To stop the cleaning mode at any moment,
move one of the two knobs from the cleaning
position.
Do not attempt to open the door while the door is
locked. The "AUTO LOCK" writings will flash until the
motor stops. When they are displayed, the door
cannot be opened. Check that the door has been
locked and will not open before starting the Self-Clean
mode.
If door does not lock, rotate the cooking mode knob
into the OFF position and do not start self-clean;
phone for service.
If the door is in the open position when this mode is
selected, the "AUTO LOCK" writings will flash until the
door is closed. The latch doesn't move.

To Change the Cleaning Time

1. To change the setting from 3 hours, select
either 2 hours for light soil or 4 hours for
heavy soil immediately before starting.
2. To change the hours, touch the [TIME] key.
3. The hours will flash.
4. Use [INC] or [DEC] keys to change the value.
28
Setting the Self-Clean Mode

To Delay the Start of Cleaning

In order to check the cleaning or the stop time during a
delayed clean, simply touch the [TIME] key until "TIME"
or "STOP TIME" writings are displayed.
5. To change the minutes, touch the [TIME] key
again.
6. The minutes will flash.
7. Use [INC] or [DEC] keys to change the value.
Hold the key to change by 10 minutes steps.
Touch [TIME] or wait a few seconds to confirm
8.
the new value.
1. Follow steps 1 through 7 above.
2. Touch the [TIME] key and verify that "STOP
TIME" appears on the display. The hours will
begin flashing.
3. Use [INC] or [DEC] keys to change the stop
time value.
4. To change the minutes, touch the [TIME] key,
the minutes will flash.
5. Use [INC] or [DEC] keys to change the value.
Hold the key to change by 10 minutes steps.
Touch [TIME] or wait a few seconds to confirm
6.
the new value.
7. The latch starts moving to lock the oven door,
the display shows "DELAY".
8. When the delay time expires, self-cleaning will
start.
9. At the end of the programmed cleaning time,
the oven will automatically turn off.
10. "End" will appear on the temperature display,
"CLEAN" on the mode display and "TIME" on
the clock display will start flashing until the
[TIME] key is touched or the knob is moved to
the OFF position.
Use & Care Manual
ENGLISH