Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Kogan KAWLMFM43MA
Summary of Contents for Kogan KAWLMFM43MA
- Page 1 TILT EXTENDABLE FULL MOTION WALL MOUNT (SUITABLE FOR 1 KAWLMFM43MA...
-
Page 2: Safety And Warnings
SAFETY & WARNINGS • Read the entire user guide before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, contact help.Kogan.com for support. • Use with products heavier than the rated weights indicated may result in instability causing possible injury. - Page 3 COMPONENTS A Bracket / wall mount (x1) B VESA mount C Spirit level (x1) extension arms (x4) D Extension arm bolt E Extension arm nut F Spanner M5x12 (x4) (x4) (x1) M-A Screw M-B Screw M-C Spacer (x4) M6 x 14 (x4) M8 x 20 (x4) W-A Screw W-B Wall anchors...
- Page 4 INSTALLING MOUNT TO WALL Extend the Bracket / wall mount (A) out to full length. Using a Phillips head screwdriver (not supplied), unscrew and remove the 3mm screws attaching the arm wall mount. Retain these screws nearby for later use.
- Page 5 • Using a pencil, and the Spirit level (C), mark the desired position for the mount on your wall, using the wall mount to serve as a template for the hole positions. If mounting on dry wall or plaster-board, use a stud finder first to check positions of wall studs and ensure the position is free from electrical wiring.
- Page 6 Drywall / plaster: Position the wall mount in line with the pilot holes and secure to the wall using washers (W-C) and ST6.3x55 screws (W-A). Do not use the wall anchors. Masonry / concrete: Insert wall anchors (W-B) into the drilled holes. Position the wall mount in line with the holes and secure to the wall using washers (W-C) and ST6.3x55 screws (W-A).
- Page 7 INSTALLING BRACKET TO TV Extension arms (B) are not required. Attach the Extension arms (B) to the bracket using the bolt and nut set (D, E), tightening with the included spanner (F). VESA: 100x200 VESA: 200x100 VESA: 75x75 & 100x100 100mm 100mm 200mm...
- Page 8 • With the extension arms successfully fitted (if required) VESA holes and secure using supplied screws (M-A or M-B) (depending on required length). • Check if spacers (M-C) are required to ensure correct length of screw, as per the below image.
- Page 9 SECURING TV TO MOUNT Step 1: • With the top 2 screws (from Step 2) loosely in place, hook the TV with bracket installed onto the wall mount arm. Note: 2 people should carry the TV to prevent damage. • Once in place, attach the lower 2 screws, then tighten all 4. Do not overtighten.
- Page 10 Step 2:...
- Page 11 ADJUSTMENTS To adjust the TV vertical angle, loosen the lower 2 screws and move the bracket into the desired position before retightening. Do not overtighten. To rotate the TV, loosen the 2 central nuts and move the bracket into the desired position before retightening.
- Page 12 Need more information?
Need help?
Do you have a question about the KAWLMFM43MA and is the answer not in the manual?
Questions and answers