Advertisement
Table of Contents
PRECAUTIONS:
Please read and understand this entire manual before installing or operating this light fixture.
• This light fixture should be installed outdoors to a wall or eave.
• The solar panel should be installed where it can get the most sun.
• Do not cut the solar panel wire. Discontinue use if the wire becomes frayed or broken.
• Do not immerse components in liquid.
• Do not use any other charging device other than the single solar charging panel provided with this light. Doing so may result in injury
or damage to the light and voids any warranty.
• Position the cord so it is securely fastened and will not result in hazards (such as tripping).
• Your motion light and solar panel are both water-resistant.
• Never look directly into the solar motion light when illuminated.
• Operating temperature -13
F to 113
o
WARNING: To prevent SERIOUS INJURY OR DEATH, never allow children near the battery. If a battery is swallowed, seek
immediate medical attention.
WARNING: When replacing the battery, DO NOT use an old battery. Make sure to match the replacement battery specifications with the battery
that has been removed (Li-ion battery, 18650 3.7V 2200mAh). DO NOT DISPOSE OF THE Battery IN FIRE. Battery MAY LEAK OR EXPLODE.
HARDWARE:
MOTIO
SOLAR MOTION LIGHT
1 X Security Light
1 x Motion Light
1 x Motion Light
TOOLS REQUIRED:
6 x Mounting Screws
6 x Mounting Screws
6 x Wall plugs
6 x Wall plugs
place
Please read these instructions thoroughly prior to installation, then store in a safe place for future reference.
Please read these instructions thoroughly prior to installation, then store in a safe place for future reference.
Please read these instructions thoroughly prior to installation, then store in a safe place for future referenc
Power Drill
If you have questions or are missing parts, please contact customer service at 1-888-745-4837
INSTALLATION INSTRUCTIONS: 356-9476 (CL-SM2200L-3H)
2200 LUMEN 3-HEAD SOLAR MOTION ACTIVATED SECURITY LIGHT
F (-25
C to 45
C)
o
o
o
SOLAR MOTION LIGHT
1 X Solar Panel
1 x Solar Panel
1 x Solar Panel
6 x Mounting Screws
(NOT INCLUDED)
Please read these instructions thoroughly prior to installation, then store in a sa
1 X Mounting Plate
1 X Mounting Plate
Plate
1/8" Drill Bit
for
1
1
Phillips Screwdriver
1 x Motion Light
6 x Mounting Screws
6 x Mounting Screws
Please read these instructions thoroughly prior to installation, then store in a safe place for future reference.
6 x Wall plugs
future
Ladder
SOLAR MOTION
1 x Motion Light
1 x Motion Light
6 x Mounting Screws
6 x Wall plugs
6 x Wall Anchors
6 x Wall plugs
1 X Mounting Plate
refere
Safety Glasses
Level
1 x
1 x Sola
1 X Mo
1 X Mounting Plate
1 x Mounting Bracket
1
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Patriot Lighting CL-SM2200L-3H
Summary of Contents for Patriot Lighting CL-SM2200L-3H
- Page 1 SOLAR MOTION INSTALLATION INSTRUCTIONS: 356-9476 (CL-SM2200L-3H) 2200 LUMEN 3-HEAD SOLAR MOTION ACTIVATED SECURITY LIGHT PRECAUTIONS: Please read and understand this entire manual before installing or operating this light fixture. • This light fixture should be installed outdoors to a wall or eave. • The solar panel should be installed where it can get the most sun. 1 x Motion Light • Do not cut the solar panel wire. Discontinue use if the wire becomes frayed or broken. • Do not immerse components in liquid.
- Page 2 INSTALLATION INSTRUCTIONS: 356-9476 (CL-SM2200L-3H) 2200 LUMEN 3-HEAD SOLAR MOTION ACTIVATED SECURITY LIGHT RECOMMENDED INSTALL LOCATION OF SOLAR HEIGHT: PANEL: Install the light between For the best results, install your 6.5-8.5 feet above the ground. solar panel in an area where it The fixture will provide a can absorb maximum sunlight detection distance of up during daytime hours. Be to 70 feet. aware of objects such as trees or property overhangs that may impede the panel’s ability to generate a charge. PRE-INSTALLATION: 1. Before assembly, compare package contents with the hardware list to make sure all parts are present. 2. Prior to installing the lights, an initial charge is needed and should be done in the OFF position for at least 1 to 3 days in direct sunlight before use (see page 5, fig 5 for mode selections).
-
Page 3: Care And Maintenance
• From time to time, ensure the plug between the solar panel and light is securely co INSTALLATION INSTRUCTIONS: 356-9476 (CL-SM2200L-3H) surface. • It is advisable to adjust the angle of the solar panel to optimize the exposure of the 2200 LUMEN 3-HEAD SOLAR MOTION ACTIVATED SECURITY LIGHT •... - Page 4 INSTALLATION INSTRUCTIONS: 356-9476 (CL-SM2200L-3H) 2200 LUMEN 3-HEAD SOLAR MOTION ACTIVATED SECURITY LIGHT TESTING THE LIGHT NOTE: It is recommended that the light be tested before being placed into regular operation. NOTE: Testing the light indoors or lower than 7 ft. from the ground may not enable the light to work optimally when mounted outdoors. Before placing the light in Auto operation, it is best to set Fig A the preferred light direction, then test the light and motion sensor. To set the light position: Switch the Mode to On (Fig A). This will turn the light on and you can adjust the lights to your desired position. To test the motion position: Fig B Switch the Mode to Auto. Switch the Time to Test...
- Page 5 RECOMMENDED INSTALL HEIGHT: Height Detection Coverage Detection Coverage Detection Coverage 6.5-8.25 feet above the ground. ection Coverage Detection Coverage INSTALLATION INSTRUCTIONS: 356-9476 (CL-SM2200L-3H) Sensor Sensor Least Sensitive Most Sensitive Least Sensitive Most Sensitive 2200 LUMEN 3-HEAD SOLAR MOTION ACTIVATED SECURITY LIGHT...
-
Page 6: Troubleshooting
INSTALLATION INSTRUCTIONS: 356-9476 (CL-SM2200L-3H) 2200 LUMEN 3-HEAD SOLAR MOTION ACTIVATED SECURITY LIGHT To adjust the heads for preferred detection, gently rotate the left and right lamp heads up or down or side to side. The center light is not adjustable. To adjust the motion sensor for preferred detection, gently rotate up or down or side to side. CARE AND MAINTENANCE: • From time to time, ensure the plug between the solar panel and light is securely connected. Discontinue use if the wire becomes frayed or broken. • It is advisable to adjust the angle of the solar panel to optimize the exposure to the sun during the winter months. • The solar panel should be cleaned with a damp cotton cloth regularly. That will ensure optimal performance and battery charging. Periodically, utilize the same technique to clean the lenses of the motion lights. • Never let any abrasive material come into contact with the solar panel. TROUBLESHOOTING: Problem Possible Cause Solution The light does not come on...
Need help?
Do you have a question about the CL-SM2200L-3H and is the answer not in the manual?
Questions and answers