Memorizing The Channels - Samsung HL-T5089S Owner's Instructions Manual

Memorizing the Channels

Your TV can memorize and store all of the available channels for both "off-air"(air) and cable channels. After the available
channels are memorized, use the CH
channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source,
memorizing the channels(automatic) and adding or deleting channels(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is
connected to the TV(i.e. an air or a cable system).
1 Press the MENU button.
Press the ▲ or ▼ button to select Channel, then press the ENTER button.
Press the ENTER button to select Antenna.
2 Press the ▲ or ▼ button to select Air or Cable, then press the ENTER button.
Storing Channels in Memory (Automatic Method)
3 Press the ▲ or ▼ button to select Auto Program, then press the ENTER button.
4 Press the ▲ or ▼ button to select an antenna connection, then press the ENTER
button.
➢ Air: "Air" antenna signal.
Cable: "Cable" antenna signal.
Air+Cable: "Air" and "Cable" antenna signals.
➢ If the antenna is connected to ANT 1 IN (CABLE), select Cable and if it is
connected to ANT 2 IN (AIR), select Air.
➢ If both ANT 1 IN (CABLE) and ANT 2 IN (AIR) are connected, select the
Air+Cable.
➢ If you selected Air, then go to step 6.
5 Press the ◄ or ► to select the correct analog signal source among STD, HRC, and
IRC, then press the ENTER button. If you have Digital cable, select the signal source for
both Analog and Digital.
➢
STD, HRC, and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system that exists in
your particular area. At this point the signal source has been selected.
6 The TV begins memorizing all available stations.
When pressing the ENTER button during a storing process, the message Would you
like to stop the auto channel selection? is displayed. Select Yes by pressing the ◄
or ► button.
Press the EXIT button to exit.
➢ The TV must be connected to an antenna/cable in order to receive digital TV
signals. Even if a particular channel is deleted from the memory, you can always
tune to that channel directly by using the number buttons on the remote control.
➢ All available DTV and analog channels are automatically stored in memory.
It takes approximately 3 to 10 minutes to memorize channels.
and CH button to scan through the channels. This eliminates the need to change
English - 21
Antenna : Air
Channel List
Auto Program
Clear Scrambled Channel
Fine Tune
Signal Strength
LNA : On
Antenna : Air
Air
Cable
Channel List
Auto Program
Clear Scrambled Channel
Fine Tune
Signal Strength
LNA : On
Auto Program
Select the antennas to memorize
Air
Cable
Air+Cable
Move Enter
Auto Program
Select the cable system.
Analog STD HRC
Digital
STD HRC
Move Enter
Auto Program
Auto Program in Progress.
Digital Channels are added on the favorite
channel list.
Stop
Enter
Auto Program
Would you like to stop the auto channel
selection ?
Digital Channels are added on the favorite
channel list.
Yes No
Move Enter
Auto Program
Auto Program is incomplete.
3 channels are memorized.
Air : 1 Cable : 2
OK
Enter


Start
Start
Start
Return
IRC
IRC
Return
Air 10
3%
Skip
Air 10
3%
Return
Return