Advertisement
3 Installation
Before the calling the nearest Authorized
Service for the installation of the dryer, ensure
that electrical installation and water drain is
appropriate referring to the user's manual.
If they are not suitable, contact a qualified
electrician and technician to make necessary
arrangements.
C
NOTE
•
Preparation of the dryer's location
as well as the electrical and waste
water installations is under customer's
responsibility.
A
WARNING!
•
Prior to installation, visually check if the
dryer has any defects on it. If the drier
is damaged, do not have it installed.
Damaged products cause risks for your
safety.
3.1 Appropriate installation location
Install the dryer on a stable and level surface.
Dryer is heavy. Do not move it by yourself.
•
Operate your dryer in a well ventilated,
dust-free environment.
•
The gap between the dryer and the
surface should not be reduced by the
materials such as carpet, wood and tape.
•
Do not cover the ventilation grills of the
dryer.
•
There must not be a lockable, sliding or
hinged door that may block the opening
of the loading door in the place where
your dryer is to be installed.
•
Once the dryer is installed, it should stay
at the same place where its connections
have been made. When installing the
dryer, make sure that its rear wall does
not touch anywhere (tap, socket, etc.).
•
Your dryer can be operated at
temperatures between +5°C and +35°C.
If the operating conditions fall outside
of this range, operation of the dryer will
be adversely affected and it can get
damaged.
Dryer / User Manual
•
The rear surface of the tumble dryer shall
be placed against a wall.
•
This dryer is not able to be wall-mounted
as it would be too too heavy for the walls
B
DANGER!
•
Do not place the dryer on the power
cable.
3.2 Removing the transportation
safety assembly
A
WARNING!
•
Remove the
transportation
safety assembly
before using the
dryer for the first
time.
•
If the door swing
side of your
appliance can
be modified, see
the reversible
door mounting
instructions.
9
Advertisement
Need help?
Do you have a question about the C HD C92 WWGD UK and is the answer not in the manual?
Questions and answers
how to reset hotpoint condencing tumble dryer that has no pin hole
The manual does not provide specific instructions on resetting the Hotpoint C HD C92 WWGD UK condensing tumble dryer without a pinhole. However, you can try the following general reset steps:
1. Turn Off the Dryer – Switch off the dryer using the control panel and unplug it from the power source.
2. Wait for a Few Minutes – Leave the dryer unplugged for at least 5-10 minutes to allow any residual power to discharge.
3. Plug It Back In – Reconnect the power supply and switch the dryer back on.
4. Check for Errors – If the dryer has an error code, consult the manual for troubleshooting steps.
5. Try Running a Program – Select a drying program and press the Start/Pause button to see if the issue is resolved.
If the problem persists, consider contacting Hotpoint customer support for further assistance.
This answer is automatically generated