Advertisement
A
If the dryer is installed near to
a gas or coal stove, provide a heat
insulating plate (85 cm x 57 cm)
in between, as the side facing the
stove is covered with aluminium foil.
A
Exhaust air must not be
discharged into a fl ue which is
used for discharging fumes from
appliances burning gas or other
fuels.
A
The appliance must not be
installed behind a lockable door, a
sliding door or a door with a hinge
on the opposite side to that of the
tumble dryer, in such a way that a
full opening of the tumble dryer door
is restricted.
A
The appliance shall be placed
against the wall to limit access to its
rear side.
A
Take care not to use a carpet
which obstructs ventilation openings
in the base of the dryer.
A
If you want to stack the
dryer on a washing machine, first
contact our After-Sales Service or
your specialist dealer to verify the
complete list of suitable models.
Dryer / User Manual
The stacking is only possible
if the dryer is attached to the
washing machine by means of the
appropriate stacking kit available
through our After-Sales Service or
your specialist dealer. Instructions
for the correct assembly are
supplied with the stacking kit.
ELECTRICAL WARNINGS
A
It must be possible to
disconnect the appliance from the
power supply by unplugging it if
plug is accessible, or by a multi-pole
switch installed upstream of the
socket in accordance with the wiring
rules and the appliance must be
earthed in conformity with national
electrical safety standards.
A
Do not use extension leads,
multiple sockets or adapters. The
electrical components must not
be accessible to the user after
installation. Do not use the appliance
when you are wet or barefoot. Do
not operate this appliance if it has
a damaged power cable or plug, if
it is not working properly, or if it has
been damaged or dropped.
A
If the supply cord is damaged,
it must be replaced with an identical
one by the manufacturer, its service
agent or similarly qualifi ed persons
in order to avoid a hazard - risk of
electric shock.
5
Advertisement
Need help?
Do you have a question about the C HD C92 WWGD UK and is the answer not in the manual?
Questions and answers
how to reset hotpoint condencing tumble dryer that has no pin hole
The manual does not provide specific instructions on resetting the Hotpoint C HD C92 WWGD UK condensing tumble dryer without a pinhole. However, you can try the following general reset steps:
1. Turn Off the Dryer – Switch off the dryer using the control panel and unplug it from the power source.
2. Wait for a Few Minutes – Leave the dryer unplugged for at least 5-10 minutes to allow any residual power to discharge.
3. Plug It Back In – Reconnect the power supply and switch the dryer back on.
4. Check for Errors – If the dryer has an error code, consult the manual for troubleshooting steps.
5. Try Running a Program – Select a drying program and press the Start/Pause button to see if the issue is resolved.
If the problem persists, consider contacting Hotpoint customer support for further assistance.
This answer is automatically generated