Advertisement
Press the Ending In and Buzzer buttons
simultaneously for 3 seconds to activate the
child lock.
The child lock has to be deactivated to be
able to start a new program after the current
program is finished or to be able to interfere
with the program. To deactivate the child lock,
keep the same buttons pressed for 3 seconds.
C
NOTE
•
When the child lock is activated, the child
lock warning indicator on the screen
turns on.
•
Child lock deactivates when the drying
machine is turned off and on by the On/
Off/Cancel knob.
C
NOTE
•
When the drying machine runs and
the child lock is active, it beeps twice
when the program selection knob is
turned. If the child lock is deactivated
without returning the program selection
knob to its previous position, program
will terminate due to the change in the
program selection knob position.
5.9 Changing the program after it is
started
You can change the program you selected to
dry your laundry with a different program after
the drying machine starts running
•
For instance, select Extra Dry program
by turning the On/Off/Program selection
knob to select Extra Dry instead of Iron
Dry.
•
Press the Start/Stand-by button to start
the program.
16
Adding and removing clothes during
stand-by
If you want to add or remove clothes to/from
the drying machine after the drying program
starts:
•
Press the Start/Stand-by button to put
the drying machine in Stand-by state. The
drying operation stops.
•
Open the loading door while in Stand-
by state, and close the door after you
remove or add laundry.
•
Press the Start/Stand-by button to start
the program.
C
NOTE
•
Adding laundry after the drying operation
starts may cause the dried laundry inside
the machine to mix with wet laundry and
leave the laundry damp at the end of
operation.
•
Adding or removing laundry during drying
may be repeated as many times as you
wish. But this operation continuously
interrupts the drying operation, and thus
increases program duration and energy
consumption. So, it is recommended to
add laundry before the program starts.
•
If a new program is selected by turning
the program selection knob while the
drying machine is in stand-by, the
running program terminates.
WARNING!
•
Do not touch the inner surface of the
drum while adding or removing clothes
during a continuing program. The drum
surface is hot.
Dryer / User Manual
Advertisement
Need help?
Do you have a question about the C HD C92 WWGD UK and is the answer not in the manual?
Questions and answers
how to reset hotpoint condencing tumble dryer that has no pin hole
The manual does not provide specific instructions on resetting the Hotpoint C HD C92 WWGD UK condensing tumble dryer without a pinhole. However, you can try the following general reset steps:
1. Turn Off the Dryer – Switch off the dryer using the control panel and unplug it from the power source.
2. Wait for a Few Minutes – Leave the dryer unplugged for at least 5-10 minutes to allow any residual power to discharge.
3. Plug It Back In – Reconnect the power supply and switch the dryer back on.
4. Check for Errors – If the dryer has an error code, consult the manual for troubleshooting steps.
5. Try Running a Program – Select a drying program and press the Start/Pause button to see if the issue is resolved.
If the problem persists, consider contacting Hotpoint customer support for further assistance.
This answer is automatically generated