Computer Compatibility Chart - Pioneer PDP-4270HD Operating Instructions Manual

Enjoying through External Equipment
12

Computer compatibility chart

Resolution Frequency
720 × 400
70 Hz
640 × 480
60 Hz
72 Hz
75 Hz
800 × 600
56 Hz
60 Hz
72 Hz
75 Hz
1024 × 768
60 Hz
70 Hz
75 Hz
1360 x 768 60 Hz
G-LINK™ connection
You need to make this connection, so that the TV Guide On
Screen™ system works with the Plasma Display System to
enable the system's recording features with your VCR.
NOTE
• In order to use your VCR with the TV Guide On Screen™
system, you have to correctly set up for the TV Guide On
Screen™ system. See "TV Guide On Screen™ System Setup"
on page 38.
• Make sure to position the G-LINK cable's wand so that its
light emitting section faces the remote control sensor on the
VCR.
• Make sure to place the VCR into the standby status when
presetting TV programs for recording with the TV Guide On
Screen™ system.
• Be careful not to leave the cable looped when making the
connection.
76
En
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core to the
connector end of the G-LINK cable as shown.
Ferrite core
CAUTION
• Regarding the G-LINK cable, attach the supplied ferrite core.
If you do not do this, this Plasma Display will not conform to
mandatory FCC standards.
When connecting the VCR
Plasma Display (rear view)
AV cable
(commercially G-LINK cable (supplied)
available)
VCR
G-LINK cable
Pull the cable slightly to
take up any slack .
A
A
As close as possible
Viewed from below of
the Plasma Display
G-LINK cable's wand
Point to the remote
control sensor