Before Using; Checking Accessories; Preparing The Remote Control; Remote Control Operation - Pioneer DV-AX10 Operating Instructions Manual

Before Using

Checking Accessories

Please confirm that the following were received with
the player.
Audio cord
Video cord
BNC to RCA/phono adapter (x3)
Remote control unit
AA/R6P batteries
When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country or area.
H048 En
Operating instructions (this manual)

Remote Control Operation

8
En
7m (23 feet)

Preparing the Remote Control

Inserting batteries into the remote
control
1
Push down on the tab on the
battery compartment cover,
and pull out in the direction
indicated by the arrow.
2
Insert batteries.
Make sure to match the plus (+)
and minus
(–) polarity guides on the
batteries with the marks inside
the battery compartment.
3
Close the cover.
Notes
• Do not mix old and new batteries.
• When replacing batteries, use all new batteries.
• When not using the remote control for a long period of
time (over 1 month), remove the batteries to avoid
possible damage from battery corrosion. If battery
leakage occurs, wipe the battery liquid from the battery
component, then insert new batteries.
When operating the remote control, point it at the
remote sensor (Î) located on the player's front panel.
The remote control can be used up to 7 m (23 feet) from
the player and within a 30° angle on each side of the
sensor.
Notes
• Exposing the remote sensor to direct sunlight or strong
light may cause faulty operation.
• If the CONTROL IN jack on the player's rear panel is
connected to the CONTROL OUT jack of another
component, point the remote control at the other
component to operate the player. Operation will not be
possible when pointed at this player (page 1 1).