Table of Contents
Advertisement
Remote control unit
Projector control panel
RGB INPUT
LAMP
POWER
AUTO SETUP
STANDBY(R)
ON(G)
MENU
q Power indicator
(pages 27,
28
and 45)
This indicator illuminates red when
the MAIN POWER switch is turned
on (standby mode), and illuminates
green when the power is turned on
and a picture starts to be projected.
When the WEB STANDBY is set
to "ON", the cooling fan operates
and the power indicator on the
projector flashes slowly in red.
w RGB INPUT indicator
(page 55)
This indicator shows whether a
signal is being input to the RGB
input connectors (RGB 1 IN/RGB
2 IN). When an input signal is
detected, the indicator illuminates.
e LAMP indicator
(page 50)
This indicator illuminates when it is
time to replace the lamp unit. It flashes
if a circuit abnormality is detected.
r Input select (INPUT, RGB,
VIDEO) buttons
(page 27)
TEMP
INPUT
SHUTTER
ENTER
POWER
SETUP
RGB
LASER
VIDEO
PAGE
R-CLICK
FREEZE SHUTTER
FUNC1
Computer
t TEMP indicator
(page 49)
This indicator illuminates if an
abnormally high temperature is
detected inside the projector or
around it. If the temperature rises
above a certain level, the power
supply will be turned off
automatically and the indicator
will illuminate or flash.
y POWER button
(pages
27
and 28)
u AUTO SETUP button
(pages
27
and 55)
If this button is pressed while a
picture is being projected, the
projection settings will be
adjusted automatically in
accordance with the signal being
input. In addition, the angle of tilt
of the projector will be
automatically detected and
adjusted in order to correct any
keystone distortion. ("AUTO
SETUP" will appear on the
screen during adjustment.) Set
AUTO
MENU
ENTER
STD
Pro jector
15
Advertisement
Table of Contents
