Table of Contents
Advertisement
About the RGB INPUT indicator
The RGB INPUT indicator can be used to check whether an RGB/YP
signal is being input. Refer to the table below for details.
RGB INPUT
indicator status
Illuminated
Switched off
About the automatic setup function
If you press the AUTO SETUP button, the items given in the table below will
be set automatically. The setting details change according to the signal
which is being input. Refer to the table below for details.
Horizontal/
vertical
position
VIDEO/S-VIDEO/
NETWORK/SD CARD
YP
P
B
R
Dot Clock
frequency
is 140 MHz
or higher
Signal other
than above
NOTE:
• If the edges of the projected picture are indistinct, or if a dark picture is being
projected, the automatic setup processing may stop automatically before it is
complete. If this happens, project a different picture and then press the AUTO
SETUP button once more, or make the above adjustments manually.
• If you would like to make further adjustments to the picture, use the menu
commands which are listed on page
Standby
A signal is being input to
either the RGB1 IN or
RGB2 IN connector.
No signal is being input to
either the RGB1 IN or
RGB2 IN connector.
Dot clock/
clock phase
Yes
No
29
Power supply status
On (projecting)
A signal is being input to
the connector selected
using the input select
buttons.
No signal is being input to
the connector selected
using the input select
buttons.
Auto RGB
input select
Yes
and subsequent pages.
P
B
R
Automatic
vertical
keystone
correction
Yes
Yes
Yes
55
Advertisement
Table of Contents
