Table of Contents
Advertisement
Setting up the projector
q q Insert the wireless card into the projector
For details of installing and removing the wireless card, refer to "Wireless card" on
page 83.
w w Press the MENU button to display the menu.
e e Use
and
"Network setting" screen.
r r Press the ENTER button to display "Network setting" setting
screen.
Status
Five different LAN settings (LAN 1-5) can be stored on the projector.
Selecting from LAN 1-5 with
status will be displayed.
To change the status, choose "RUN" from "Setting Wizard" and press the ENTER
button to move to the LAN setup wizard.
To enable the status, choose "OK" from "Setting Wizard" and press the ENTER
button.
WEP Wired Equivalent Privacy
The projector can encrypt the image data.
However, when the encryption function is enabled, it takes more time to transmit
images.
Selecting from KEY 1-4 with
WEP data will be displayed.
To change the setting of WEP, choose "RUN" from "Setting Wizard" and press the
ENTER button to move to the WEP setup wizard.
To enable the WEP data, choose "OK" from Setting Wizard and press the ENTER
button.
LAN Setup Wizard
IP address
Assign an IP address to the projector.
Make setting according to the typical setting. However, the same IP address as that
of the PC with which the projector communicates cannot be used.
Use
and
fields. Press the ENTER button when the setting is completed.
Subnet mask
Set the subnet mask of the projector.
Make setting according to the typical setting.
Use
and
buttons to change the value, and use
the fields.
Press the ENTER button when the setting is completed.
94
buttons to display
and
and
buttons to change the value,
NETWORK
buttons, press the ENTER button and its
buttons, press the ENTER button and the
and
and
STATUS
LAN1
WEP
DISABLE
SELECT:[ ↑ ][ ↓ ]
ENTER:[ENTER]
ADJUST:[←][→]
ESC :[MENU]
buttons to switch the
buttons to switch
Advertisement
Table of Contents
