Project an image
Preparations
•
Confirm the connections of the peripheral devices
( page 16, 17) and power cord ( page 18).
•
Switch on the power
( page 20) to start projecting.
•
Select the input signal and adjust the image.
SELECT THE INPUT SIGNAL
1
Switch on the connected devices.
When playing a connected DVD player, if SIGNAL
SEARCH (DISPLAY OPTION menu) is set to
ON, the input signal is detected and projected
automatically when the projector is switched on.
( page 35)
INPUT GUIDE (DISPLAY OPTION
•
Set the
ON-SCREEN DISPLAY menu) to DETAILED. If
the projector cannot detect any input signal, the
"Computer connection guide" will be displayed.
( page 33)
2
Select an input signal.
The image selected with any of the [INPUT
SELECT] button is projected.
NOTE:
•
Change the settings in the
connected device for example DVD, video tape, etc., to be
played. (
page 28)
•
Confirm the aspect ratio of the screen and image.
Select the optimum aspect ratio. (
POSITION THE IMAGE
When setting up the projector for the first time or
setting up at a new place, you must perform the
following operations.
1
Adjust the vertical angle of the projector.
•
Place the projector at the right angle from the
screen.
22 ENGLISH
PICTURE menu according to the
page 31)
•
Press the leg adjuster button
the vertical projection angle. Then, adjust the
projected image to the center of the screen.
Rear leg adjuster
2
Adjust the projection size and focus.
•
Turn the zoom and focus rings to adjust the
projected image.
NOTE:
•
When you adjust the zoom after adjusting the focus, you
may need to adjust the focus of the image again.
•
If the projected image slants to the right or left, turn the rear
leg adjuster to adjust the angle of the projector.
•
If keystone distortion occurs, see KEYSTONE.
(
page 30)
and adjust
Zoom ring
(ZOOM)
Focus ring
(FOCUS)