Position Menu; Position Menu; Rgb/Yp B Pr; Note - Panasonic PT-LB2U Operating Instructions Manual

Menu operation (continued)
▌ RGB/YP P
B R
(For RGB/YP P input signal only)
B R
Select the signals to be input to the COMPUTER 1 IN
and COMPUTER 2 IN terminals.
Change
Change setting
setting
AUTO Automatic adjustment
RGB For RGB signals
YP P For YP P
B R B R

NOTE:

• AUTO mode is selected by default.
• Select RGB or YP P according to the input signal if the
B R
image is not normally projected during AUTO mode.
The function only becomes effective when certain signals
are input:
(VGA60, 480i, 576i, 480p, 576p, 1 080/60i, 1 080/50i,
720/60p, 720/50p)

POSITION MENU

Remote control
MENU MENU RETURN
MENU MENU RETURN
ENTER ENTER
ENTER ENTER
AV
AV
FREEZE MUTE
FREEZE MUTE
COMPUTER VIDEO
COMPUTER VIDEO
DEFAULT DEFAULT FUNCTION
DEFAULT FUNCTION DEFAULT INDEX- WIN.
INDEX- WIN.
Set the selected item with [  ].
▌

REALTIME KEYSTONE

If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled
surface; the keystone will be automatically corrected.
Change
Change setting
setting
OFF Deactive
ON Active
NOTE:
• If the detected tilt of the main unit is ± 5 %, even if you
set ON, the distortion will not be corrected automatically.
Because the priority is not to correct the distortion, but to
avoid the image quality deteriorated by correcting.
• If you need to correct the keystone, you can correct the
distortion manually by adjusting the KEYSTONE.
30  ENGLISH
Change
Change setting
setting
signals
Control panel
INPUT
INPUT
SELECT
SELECT
STANDBY
STANDBY
(R)
(R)
ON(G)
ON(G)
ENTER ENTER
ENTER ENTER
LAMP
LAMP
TEMP
TEMP
FUNCTION
MENU MENU MENU MENU FUNCTION
Change
Change setting
setting
▌

KEYSTONE

If you need to correct the angle of the projection even
when the REALTIME KEYSTONE is activated, you can
correct the keystone manually.
Image
NOTE:
• You can correct the distortion ±30 ° from the plane.
• For a better image quality, install the projector to minimize
distortion.
• The result of the keystone correction will affect the aspect
ratio and the size of the image.
• The image is distorted momentarily when the keystone is
corrected.
▌

SHIFT

SHIFT
Horizontal (H): Press [  ] to move the image
horizontally.
Vertical (V): Press [  ] to move the image
vertically.
NOTE:
• This function can be adjusted by pressing the
buttons directly.
▌

DOT CLOCK

If there are interference patterns on the projected image
(referred as moire or noise), minimize it by pressing
[  ] to adjust the clock frequency. (For RGB (Still
image) input signal only)
NOTE:
• DOT CLOCK needs to be adjusted before adjusting the
CLOCK PHASE.
Operation
ENTER
ENTER
0
H
V 0
