Cable Specifications; Control Commands - Panasonic PT-LB2U Operating Instructions Manual

Technical Information (continued)

Cable specifications

(When connected to a personal computer)

Control commands

The following commands are used for control of the projector with a computer. (Operation commands)
Command Control contents
PON Power on
POF Power off
AVL Volume
IIS Input
Lamp condition
Q$S
query
OSH AV mute
NOTE:
• If STANDBY MODE is set to ECO, only PON and Q$S command can be used in the standby mode.
MENU LOCK PASSWORD
To reset the password to the default setting AAAA, perform the following when the MENU LOCK PASSWORD
request screen is displayed.
1) Press and hold the <AUTO SETUP> button of the remote control or the <INPUT SELECT> button of the
control panel and the▲button of the control panel together for at least 2 seconds.
2) Press and hold▼button for at least 2 seconds.
PASSWORD HAS BEEN INITIALIZED. is displayed on the MENU LOCK PASSWORD request screen.
52  ENGLISH
• The PON command is ignored during lamp ON control.
• If a PON command is received while the cooling fan is operating after the lamp has switched off,
the lamp is not turned back on again straight away in order to protect the lamp.
Parameter:
000 - 063 (Adjustment value 0 - 63)
Parameter:
VID = VIDEO SVD = S-VIDEO
RG2 = COMPUTER 2 IN
Call back:
0 = Standby 1 = Lamp on control active
Turn off the projection and sound temporarily.
Send the command to switch between off and on. (
Do not send the command consecutively.
0 = Off 1 = On
Projector
Remarks
RG1 = COMPUTER 1 IN
2 = Lamp on 3 = Lamp off control active
page 23)

PC
(DTE)