Unpacking And Installation Instructions - DCS MO-24SS Use And Care Manual

Unpacking and Installation Inst ructions
Unpacking and Examining Your Oven
Remove: all packing materials from inside the oven
cavity; however, DO NOT REMOVE THE WAVEGUIDE
COVER, which is located on the right cavity wall. Read
operate the oven and contact your dealer or DCS
AUTHORIZED SERVICER.
Choosing a Location for Your Oven on
the counter
You will use the oven frequently so plan its location
for ease of use. It's wise, if possible, to have counter
space on at least one side of the oven. Allow at least 2
inches on the sides, top and at the rear of the oven for
air circulation.
Choosing a Location for Your Oven if built-in
Your oven can be built into a cabinet or wall by itself
or above any DCS wall oven listed below using DCS's
Built-in Kits, either the MOSTK27 or the MOSTK30. The
MOSTK27 is for a 27" wall oven, while the MOSTK30
accommodates installation above 30" wall ovens.
OVEN FRONT
The applicable wall ovens and warming ovens are
as follows:
OVENS - WO 127, WO 130, WOS127, WOS130
WARMING OVENS - WD 27, WD 30, WDS27, WDS30,
WDSI
Do not built-in above any other gas or electric
wall oven.
enclosures and SAVE
the Operation Manual.
Check the oven for any
damage, such as mis-
aligned or bent door,
damaged door seals
and sealing surfaces,
broken or loose door
hinges and latches and
dents inside the cavity or
on the door. If there is
any damage, do not
TRIM KIT FRAME
ASSEMBLE
OVER OVEN INSTALLATION
MICROWAVE
CUTOUT
40 1/4"
(1022MM)
OVER WARMING OVEN INSTALLATION
MICROWAVE
CUTOUT
RECOMMENDED
HEIGHT
36"
(914MM)
See Built-in Kit Installation Instructions for proper loca-
tion when building in above the specified wall ovens.
Carefully follow both the wall oven installation instruc-
tions and Built-in Kit instructions.
The opening in the wall or cabinet must be within the
following dimensions:
A HEIGHT
B WIDTH
C DEPTH
4
TOP OF
MICROWAVE
SHELF
1"
(25MM)
WALL
OVEN CUTOUT
2"
(51MM)
WARMING
OVEN CUTOUT
1
: 17" + / ", -0
16
3 1
: 24 / " + / ", -0
4 16
: minimum 20"