Tuner Operation - Aiwa CSD-FD82 Operating Instructions Manual

PHONES \
TUNER / BAND
POWER STANDBY/
ON 6
QSOUND, T-BASS,
3-MODE EQ
REPEAT /
MODE / SLEEP
A

TUNER OPERATION

1
Press * TUNER/BAND repeatedly to
select the desired band.
The power is turned on and the previously tuned
station is received.
* or BAND on the remote control (applicable
when the AC cord is connected)
2
Press r, t (TUNING -, +) to select
a station.
After listening, press POWER STANDBY/ON6 to
turn the power off.
For better reception
FM
Extend the rod antenna
and orient it for the best
reception.
For quick tuning (Auto Search)
Keep r, t pressed until the tuner starts
searching for a station. When a station is tuned to, the
search stops.
If the broadcast signal is weak, it does not stop. To
stop the search manually, press r or t.
To listen with the headphones
Connect headphones with a stereo mini plug to the
PHONES \ jack on the rear of the unit.
6
ENGLISH
FM AM
AM
The antenna is inside the
unit. Position the unit for
the best reception.
* REPEAT/MODE/SLEEP
- If an FM stereo broadcast contains noise, press the
button so that is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
- If a high-pitched sound is heard during AM recording,
press the button repeatedly to display "b1" or "b2", so
as to eliminate the noise.
* or MODE on the remote control
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/
step. If you use the unit in an area where the frequency
allocation system is 9 kHz/step, change the interval as
follows.
1 Press TUNER/BAND.
2 Press POWER STANDBY/ON6 while pressing
TUNER/BAND.
When the AM tuning interval is changed, the preset
stations are cleared.
NOTE
If the unit picks up noise from other electrical
appliances nearby, like a TV or fluorescent lights, move
the unit.
VOL UP, DOWN
a PAUSE / SET
s STOP / CLEAR
d PLAY / DIR / PRESET
( c PLAY / PRESET)
r, t
(TUNING -, +)