Tuner Operation; Presetting Stations - Aiwa CSD-TD20 Operating Instructions Manual

\
CD, RADIO/BAND,
POWER6STANDBY/
TAPE
A

TUNER OPERATION

1
Press RADIO/BAND repeatedly to select the
desired band.
FM
The power is turned on and the previously tuned
station is received.
The RADIO indicator lights up.
2
Press r, t (TUNING -, +) to select a
station.
During FM stereo reception, STEREO is displayed.
After listening, press POWER 6 STANDBY to turn the
power off.
For better reception
FM
Extend the rod antenna and
orient it for the best reception.
For quick tuning
Keep r, t pressed until the tuner starts searching for
a station. When a station is tuned to, the search stops.
If the broadcast signal is weak, it does not stop. To stop
the search manually, press r or t.
REPEAT/FM MODE/OSC
- If an FM stereo broadcast contains noise, press the
button so that MONO is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
- If a high-pitched sound is heard during MW or LW
recording, press the button repeatedly until the noise is
reduced. Its position can be checked by "•" being on or
off the display.
To change the MW tuning interval
The default setting of the MW tuning interval is 9 kHz/step.
If you use this unit in an area where the frequency
allocation system is 10 kHz/step, change the interval as
follows.
1 Press RADIO/BAND to display FM.
2 Press s while pressing RADIO/BAND to display the
MW frequency.
When the MW tuning interval is changed, the preset
stations are cleared.
4
ENGLISH
MW LW
MW
LW
The antenna is inside
the unit. Position the unit
for the best reception.
AB
NOTE
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent lights, move the unit away.

PRESETTING STATIONS

You can preset up to 15 stations in each band.
1
Select a station.
2
Press s STOP/MEMORY once so that "M" is
displayed to store the station.
A station is assigned a preset number, beginning from 1
in consecutive order for each band.
Preset number
3
Repeat steps 1 and 2.
The next station will not be stored if a total of 15 preset
stations have already been stored for a band.
To listen to preset stations
Select a band then press e PLAY/PAUSE/PRESET
repeatedly.
To clear a preset station
Select the preset number first. Within 4 seconds, Keep s
pressed until "M" and the preset number disappear in the
display.
The higher numbers in the band are decreased by one.
STOP
MEMORY
Frequency