Advertisement
9292 Jeronimo Road
Irvine, CA 92618-1905
V300 OUTPUT CONTROL INTERFACE
PROPRIETARY INFORMATION. This document contains proprietary information which may not be duplicated,
published or disclosed to others, or used for any purpose without written permission from HID Corporation. 2004
© HID Corporation. All rights reserved.
Quick Installation Guide
Document Version 1.1
August 4, 2005
Document Number 6080-909B
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HID Vertx V300
Summary of Contents for HID Vertx V300
- Page 1 V300 OUTPUT CONTROL INTERFACE PROPRIETARY INFORMATION. This document contains proprietary information which may not be duplicated, published or disclosed to others, or used for any purpose without written permission from HID Corporation. 2004 © HID Corporation. All rights reserved. Document Version 1.1...
- Page 2 VertX V300 (CS) Quick Installation Guide Contents Introduction ..........................3 Parts List ........................... 3 Product Specifications....................... 3 Cable Specifications......................3 Overview ............................4 Step 1 Preparations ........................4 What you need before getting started ..............4 V300 ........................4 Step 2 Hardware Installation ...................... 5 Mounting Instructions ....................
-
Page 3: Parts List
VertX V300 (CS) Quick Installation Guide Introduction VertX™ CS is the first family of access controllers designed specifically for alarm dealers for direct connection to central stations. Because it was designed with central station in mind, VertX CS works with software from leading central station automation providers, including Bold Technologies, DICE and GE (MAS). -
Page 4: What You Need Before Getting Started
VertX V300 (CS) Quick Installation Guide Overview The following outlines what is required to install the V300 panel. Step 1 Preparations 1.1 What you need before getting started Prior to starting the installation, please completely read through this guide. CAUTION: The V300 is sensitive to Electrostatic Discharges (ESD). Observe precautions while handling the circuit board assembly by using proper grounding straps and handling precautions at all times. -
Page 5: Hardware Installation
VertX V300 (CS) Quick Installation Guide Step 2 Hardware Installation 2.1 Mounting Instructions 1. The V300 should always be mounted in a secure area. 2. Mount the V300 using the four mounting screws (provided) or other appropriate fasteners. Place the fasteners in the corner holes of the base. - Page 6 3. Interface Address – Set the interface address by turning the Address dial. Ensure that the V300 Interface Address is documented in the Hardware Installation Worksheet (found in the back of the HID VertX V1000 Quick Install guide). 4. Output Connections – All Output connections are used for general purpose controls.
- Page 7 Any input can be configured as a supervised input. They can be configured for resistor values of 1K – 6K Ohm. The setup of supervised inputs should be done during configuration of the VertX units via the central station automation software (host) or using the Calibrate Input tool explained in the HID VertX V1000 Quick Installation guide.
-
Page 8: Contact Information
VertX V300 (CS) Quick Installation Guide Contact Information 929274 Jeronimo Road, Irvine, CA 92618-1905 HID Corporation Web Site http://www.hidcorp.com Main Phone (949) 598-1600 (949) 598-1698 Sales (800) 210-4744 Technical Support (800) 237-7769 All National and local Electrical codes apply. •...
Need help?
Do you have a question about the Vertx V300 and is the answer not in the manual?
Questions and answers