AEG TR939M4ZC User Manual page 8

SAFETY INFORMATION
The ventilation opening in the base must not be covered by
•
a carpet, mat, or any floor covering.
WARNING: The appliance must not be supplied through an
•
external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by a utility.
Connect the mains plug to the mains socket only at the end
•
of the installation process. Make sure that the mains plug is
accessible after installation.
Ensure good air ventilation in the room where the appliance
•
is installed to avoid the backflow of unwanted gases into the
room from appliances burning gas or other fuels, including
open fires.
WARNING: Do not install the appliance in an environment
•
with no air exchange.
The appliance contains flammable gas, propane (R290), a
gas with a high level of environmental compatibility. Keep
fire and ignition sources away from the appliance. Be careful
not to cause damage to the refrigerant circuit containing
propane.
WARNING: In the appliance enclosure or in the built -in
•
structure, keep ventilation opening clear of obstruction.
WARNING: Do not damage the refrigerant circuit.
•
WARNING: Fill the water reservoir for steam treatment with
•
distilled water only. Do not use tap water or any additives. It
can cause damage to the appliance.
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre
or similarly qualified persons to avoid an electrical hazard.
Do not exceed the maximum load of 9,0 kg (refer to the
•
"Programme chart" chapter).
Wipe away lint or packaging debris that has accumulated
•
around the appliance.
8/72