Installation; Make Cutout And Installing Support Structure - DCS ADR24 Installation Manual

INSTALLATION

MAKE CUTOUT AND INSTALL SUPPORT STRUCTURE
1. Make a cut-out in your cabinet or island with the following dimensions (Fig. 3):
Note:
The cutout of each corner should be 90º for the Access Drawers to fit properly.
Vent*
Vent*
90º
* Island installation to use minimum of 3 vents
providing 10 sq. in. per vent (typical).
2. Place 2 X 4s to provide support for the Access Drawers structure in the locations indicated in the figure below
(Fig. 4).
3. Board lengths are provided in the table below (Fig. 5).
To ensure proper drawer operation, be sure your
support boards are flat & level.
B
A
4. When installing your support boards,
be sure they are level.
5. Check to be certain that the top
edges of your boards are level with
the bottom edge of the cut-out
(Fig. 6).
C
B
A
Optimal support
locations
8-3/4" 8-3/4"
Optimal support locations.
C
Fig. 4
CUTOUT DIMENSIONS
MODEL
ADR48
Vent*
ADR36
ADR30
ADR24
Fig. 3
SUPPORT BOARD DIMENSIONS
MODEL
48"
36"
30"
24"
*Dependent on application.
Front View (typical)
Support Board (typical)
4
A B
(+0,-1/8) (+1/8,-0)
46" 20"
34" 20"
28" 20"
22" 20"
A B
44" 1-1/2"
32" 1-1/2"
26" 1-1/2"
20" 1-1/2"
Fig. 5
End View (typical)
For proper support &
drawer operation, insure
that support boards are
level front to back & side
to side.
Support Boards (typical)
Fig. 6
C
24-1/2" min.
(all models)
C
3-1/2"* min.
3-1/2"* min.
3-1/2"* min.
3-1/2"* min.