Page 1
THE PROFESSIONAL WARMING DRAWER Installation Guide MODELS: WDT-30 WDTI...
Page 3
A MESSAGE TO OUR CUSTOMERS Thank you for selecting this DCS Warming Drawer. Because of its unique features, we have developed this Installation Guide. It contains valuable information on how to properly install your new Warming Drawer for years of safe and enjoyable use.
SAFETY PRACTICES AND PRECAUTIONS READ AND UNDERSTAND THESE PRECAUTIONS Read this Installation Guide thoroughly before installation. This will help to reduce the risk of fire, electric shock, or injury to persons. Remove all packaging materials from your appliance. Install according to instructions. See page 6-10 to insure proper installation and servicing. Be sure to have a qualified service technician install and ground this appliance.
SAFETY PRACTICES & PRECAUTIONS warming drawer. Utensils that are not thermally heat safe may break with sudden temperature changes. Never heat unopened containers, a build up of pressure may cause the container to burst. Grease is flammable, avoid letting grease deposits collect in the warming drawer, clean up spillage. 120 Volts AC, 5 amp min., 15 amp maximum circuit requirement.
FEATURES Vent Holes Thermostat Control Knob Moist/ Crisp Knob Removable Stainless Steel Tray Power Indicator Power Lens Indicator Light Model and Serial tag location on inside panel Stainless Steel Drawer * Not available on fully integrated model (WDTI). Fig. 01...
INSTALLATION INSTRUCTIONS MOUNTING INSTALLATION The lower rear corners of the cabinet need to provide proper support to the back of the Warming Drawer and the anti-tip mounting clips. A 120 volt AC outlet should be located no further than 36 inches from the back center of the Warming Drawer.
Page 10
INSTALLATION INSTRUCTIONS Slot Slot Center line 20" to Center line for mounting clips for WDT-30 WDTI Power cord Fig. 07 1-1/2” mounting screws Fig. 08...
Page 11
INSTALLATION INSTRUCTIONS CUSTOM PANEL INSTALLATION OF THE WARMING DRAWER INTEGRATED (WDTI) STEP 1 Remove drawer as per instructions (see Use & Care Manual). STEP 2 Check the dimensions of the front face (see fig. 09). STEP 3 Cut the custom panel to the desired dimensions, knowing that the panel must cover the paper front template plus 1/8”...
INSTALLATION INSTRUCTIONS CABINET INSTALLATION DOUBLE Wall Oven and SINGLE Wall Oven and Microwave and Warming Drawer Installation Warming Drawer Installation microwave cut-out double wall oven single cutout wall oven cutout + – + – 10 1/16" 10 1/16" 11-3/16" 11-3/16" warming drawer warming drawer cutout**...
Page 13
1. Is the circuit breaker tripped or the fuse blown? 2. Is there a power outage in the area? For warranty service, please contact your local service provider or DCS Customer Care Representative at (888) 936-7872. Before you call, please have the following information ready:...
WARRANTY LIMITED WARRANTY When you purchase a new DCS Professional Warming Drawer you automatically receive a One Year Limited Warranty covering parts and labor for the entire product for servicing within the 48 mainland United States, Hawaii, Washington D.C. and Canada. In Alaska the Limited Warranty is the same except that you must pay to ship the Product to the service shop or the service technician’s travel to your home.
Please read your Use and Care Guide. If you then have any questions about operating the Product, need the name of your local DCS Authorized Service Agent, or believe the Product is defective and wish service under this Limited Warranty, please contact your dealer or call us at: TOLL FREE 1-888-936-7872 or contact us through our web site: www.dcsappliances.com...
Page 18
REMARQUE : Inspecter le produit pour vérifier qu’il n’a pas été endommagé pendant l’expédition. En cas de dommages, contacter le transporteur et entamer une déclaration pour dommage. DCS by Fisher & Paykel n’est en aucun cas responsable des dommages pendant l’expédition.
Page 19
TABLE DES MATIÈRES MESURES DE SéCURITé ET DE PRéCAUTION CARACTERISTIQUES DU CHAUFFE-PLATS INSTRUCTIONS DE MONTAGE Specifications Montage et Installation Chauffe-plats intégré Four, micro-ondes et installation de chauffe-plats SERVICE GARANTIE 12-13...
MESURES DE SÉCURITÉ ET DE PRÉCAUTION VEUILLEZ LIRE ET BIEN ASSIMILER CES CONSIGNES Veuillez lire attentivement ce guide d'installation avant d'utiliser votre nouvel appareil. Ceci vous permettra de réduire les risques d'incendie, de chocs électriques ou de blessures. Retirez tout le matériel d'emballage de l'appareil. Procédez à...
Page 21
MESURES DE SÉCURITÉ ET DE PRÉCAUTION AVERTISSEMENT Cet appareil est conçu pour réchauffer les aliments. Pour des raisons de sécurité, n'utilisez jamais le chauffe-plats pour chauffer une pièce. Comme pour tout appareil de cuisson ou de chauffage, ne laissez jamais le chauffe-plats sans surveillance quand vous réchauffez de la nourriture, car il y a risque d'incendie.
CARACTÉRISTIQUES DU CHAUFFE-PLATS Trous de ventilation Bouton de réglage du thermostat Bouton Humide/Croustillant Plateau en acier inoxydable amovible Lentille du voyant Voyant d'alimentation d'alimentation Emplacement de l'étiquette de modèle et de série (situé sur le panneau droit intérieur de la cavité du Tiroir en acier tiroir derrière le côté...
INSTRUCTIONS DE MONTAGE SPÉCIFICATIONS La profondeur du boîtier, à partir de la bordure extérieure de la face avant jusqu'au fond du boîtier ou au mur, doit mesurer 61 cm (24 po) minimum (voir figure 02). Le chauffe-plats doit être installé dans un boîtier dont les dimensions extérieures minimum doivent être de 33,5 cm (13-1/4 po) de haut sur 76 cm (30 po) de large sur 61 cm (24 po) de profondeur.
INSTRUCTIONS DE MONTAGE MONTAGE ET INSTALLATION Les coins inférieurs arrière du boîtier doivent soutenir correctement l'arrière du chauffe-plats et les fixations antibasculement. Une prise c.a. de 120 V doit être située à moins de 92 cm (36 po) du centre arrière du chauffe- plats.
Page 25
INSTRUCTIONS DE MONTAGE 50,8 cm (20 po) De la ligne médiane à la ligne médiane pour les xations cordon d'alimentation WDT-30 WDTI Fig. 07 3,8 cm (1-1/2 po) vis de montage Fig. 08...
Page 26
INSTRUCTIONS DE MONTAGE INSTALLATION DE PANNEAU PERSONNALISÉE DU TIROIR CHAUFFANT INTÉGRÉ (WDTI) ÉTAPE 1 Retirez le chauffe-plats conformément aux instructions. (Voir le manuel d'utilisation et d'entretien.) ÉTAPE 2 Vérifiez les dimensions du gabarit devant. (Voir fig. 09.) ÉTAPE 3 Découpez le panneau fait sur mesure selon les dimensions requises, sachant que le panneau doit recouvrir le gabarit avant et dépasser de 3,2 mm (1/8 po) sur les quatre côtés afin de soigner l'aspect d'ensemble.
INSTRUCTIONS DE MONTAGE PRÉPARATION DES ARMOIRES Four double et installation de Four simple, micro-ondes et chauffe-plats installation de chauffe-plats découpe de micro-ondes découpe découpe de four de four double simple 28,4 cm (11-3/16 po) 28,4 cm (11-3/16 po) + – + –...
2. Y a-t-il une coupure de courant dans le secteur? Pour le service sous garantie, veuillez contacter votre distributeur ou contactez le centre DCS agréé le plus proche au (888) 936-7872 Avant d'appeler, veuillez avoir les informations suivantes à portée de main : Numéro de modèle (situé...
Cette garantie s'applique à l'acheteur initial et à tous les propriétaires successifs du produit dans la mesure où il s'agit d'un produit acheté pour une utilisation à domicile normale. Tout service couvert par cette garantie limitée sera assuré par Fisher & Paykel Appliances Inc. ou son agent de service DCS agréé durant les heures d'ouverture normales.
Page 30
Veuillez consulter le manuel d'utilisation et d'entretien. Si vous avez des questions concernant l'utilisation du produit, que vous cherchez le nom de l'agent de service DCS agréé local ou que pensez que le produit est défectueux et désirez le faire réparer dans le cadre de cette garantie limitée, veuillez contacter votre distributeur ou nous appeler au numéro suivant :...
Page 32
Fisher & Paykel Appliances, Inc. 5900 Skylab Road, Huntington Beach, CA 92647 Customer Care: 888.936.7872 Fax: 714.372.7003 www.dcsappliances.com As product improvement is an ongoing process, we reserve the right to change specifications or design without notice. Nous améliorons constamment ses produits et se réserve le droit de modifier les spécifications ou la conception de ses produits sans aucun préavis.