Mounting Installation - DCS WD-27-SS-OD Use And Care And Installation Manual

INSTALLATION INSTRUCTIONS

MOUNTING INSTALLATION

The lower rear corners of the cabinet need to provide proper support to the back of the Warming Drawer and the
anti-tip mounting clips. A 120 volt AC 15 amp minimum (GFI) outlet should be located no further than 36 inches
from the back center of the Warming Drawer. Illustrations suggest one possible bottom support, but the
consumer is not limited to this idea for mounting configuration.
STEP 1
The bottom rear section of the cabinet should be made of moisture protected 2x4 and needs to be installed to
hold the anti-tip mounting clips and support the weight of Warming Drawer, which is 90 lbs. If moisture
protected 2x4 is used, a min. 3" diameter hole through the wood needs to be provided for water drainage. Hole
location must correspond with drain in bottom of unit.
STEP 2
Use the screws provided to attach the mounting clips which must be installed for anti-tip safety to the bottom
support at the back. See placement dimensions in figure 05.
STEP 3
The Warming Drawer has slots on the back side where it will slide onto the anti-tip mounting clips.
Plug power cord into the AC outlet. See figure 06.
STEP 4
Fasten the front face to the cabinet by passing the screws through the holes of the front face of the warming
drawer to finish the installation. See figure 07.
NOTE: The bottom support made of moisture protected 2x4 runners or other moisture protected
construction must be capable of supporting the weight of the warming drawer. A drain hole MUST
be provided for drainage.
Slide drawer
on to Anti-Tip
21-1/2"
mounting clips
mounting clips
Fig. 05
8