DCS DishDrawer DS224 Series Installation Instructions Manual page 5

SINGLE MODELS
SERVICES SPECIFICATIONS
WATER CONNECTION
Recommended HOT
(Maximum 140°F/60°C).
Supplied hose to suit 3 / " male
8
compression fitting.
WATER SOFTENER MODELS
Refer to your DishDrawer® User Guide
for how to set up your water softener.
WATER PRESSURE Maximum
Water Softener Models 145 p.s.i. (1000kPa)
Other Models 145 p.s.i. (1000kPa)
DRAIN CONNECTION
3
Drain Hose Joiner to suit Ø / " ±
4
ELECTRICAL CONNECTION
110-120 VAC power outlet, 4.5 Amps Minimum.
WEIGHT
Full 107 lb (48kg) Prefinished
Empty 76 lb (34kg) Prefinished
THE CAVITY
+
These marks indicate mounting
screw tab locations
(refer to step 1 page 7)
Minimum
14.5 p.s.i. (100kPa)
4.3 p.s.i. (30kPa)
5 5 5
/ " and Ø / " ± / " waste tees.
64 8 64
+
NOTE: All depth measurements are taken
from the front face of the adjacent cabinetry.
NOTE: To align drawer front to adjacent
cabinetry, the product to countertop
clearance can be increased from
*
* Depth of product excludes
3
Curvature / " (10mm) and Handle.
8
LENGTH OF SERVICES
9
Drain hose - 88 / " (2250mm)
16
7
Inlet hose - 68 / " (1750mm)
8
Power supply cord - 44" (1125mm)
NOTE: Services approximately exit product 7
5
21 / " (550mm) from front; 15
8
+
+
1
/ " (3mm).
8
(FROM PRODUCT EXIT POINT)
7
/ " (189mm) from left;
16
1
/ " (393mm) from top.
2
Important!
Adjacent cabinetry must
not extend above
cavity base.
WARNING!
Be sure the edges of the services hole
are smooth or covered. If the services
hole is through a metal partition the
hole must be protected with the Edge
Protector provided to prevent damage to
the power cord or hoses.
R
R
5