Syncro; Qflash - Olympus SP-560 Instruction Manual

w ............................................................
Depending on situations such as shooting small subjects or distant backgrounds, it may be
advisable to adjust the amount of light emitted by the flash. In addition, this function is useful when
increased contrast is desired.
+2.0EV to 0.0 to -2.0EV
Press 12 to adjust, and press o.

#SYNCRO ..............................................................................

#SYNC1
#SYNC2
When the shutter speed is set to 4 sec.
Rear curtain
Shutter closes

QFLASH ........................................................................

IN
SLAVE
Selecting an emission level
• When flash is set to [SLAVE], flash mode automatically changes to [#] (Fill-in flash) for all flash
modes except [$] (Flash off).
SLAVE FLASH
1
BACK
MENU SET OK
R (still pictures) .........................................................
OFF /ON
It automatically starts recording for about 4 seconds after shooting pictures.
When recording, aim the camera microphone at the source of the sound you want to record.
30
EN
The flash fires right after the shutter fully opens (front curtain).
With the rear curtain, the flash fires just before the shutter closes (rear
curtain). You can use this setting to create interesting effects in your
picture, such as expressing the movement of a car by showing the tail-
lights streaming backwards. The slower the shutter speed, the better
the effects turn out. If the shutter speed is faster than 1/200, the flash
fires automatically with the front curtain.
4 sec.
4 sec.
Rear curtain flash fires
Allows you to take pictures using the built-in flash.
When using a commercially available slave flash that is synchronized
with the camera flash, the amount of the light emitted by the flash can
be adjusted in 10 levels.
Press 12 to select an emission level from [1] to [10], then press o.
The bigger number indicates the bigger amount of light emitted by the
flash.
• The flash can fire in sequential shooting mode, but the interval
between shots will be longer if a high emission level is set.
Adjusting the amount of light emitted by the flash
Selecting the flash timing
0
Front curtain flash
fires
Shutter button completely pressed
Setting to use an external flash
Recording sound with still pictures
Front curtain