Figure 98 Enter Monitor / Control Connection Information Dialog Box - Nortel BayStack Instant Internet 100-S Using Manual

The static address is often the same as Instant Internet's private LAN address,
but this is not necessary. If the address is not the same, Setup creates an alias
interface on Instant Internet and assign it the static address. This address is the
same as the Remote user that was set up in Contivity.
10 Click Add to enter the remote IP addresses allowed to participate in the
tunnel.
These addresses must match the networks set up in Contivity's Profiles >
networks. For more information on adding IP addresses, refer to
local or remote IP address" on page
11 Click OK to close the IPsec Configuration dialog box.
The Enter Monitor / Control Connection Information dialog box opens
(Figure 98).

Figure 98 Enter Monitor / Control Connection Information dialog box

12 Choose whether you want to monitor or control the connection by clicking the
option.
For more information, refer to
13 Enter the IP address of any machine on the opposite end of the tunnel.
You might use the IP address of the main router at the home office.
14 Select the source interface of the connection being monitored or controlled.
Usually, it is best to accept the default interface that Instant Internet provides.
Using the BayStack Instant Internet Management Software Version 7.11
Chapter 6 IP security and VPN
172.
"Using Pings" on page
195
"Adding a
173.