Nikon CoolPix S8200 Reference Manual page 210

Troubleshooting
Problem
Monitor is blank.
Monitor is hard to read.
Date and time of
recording are not correct.
No indicators displayed in
monitor.
Print date not available.
Date not imprinted on
images even when Print
date is enabled.
Screen for setting time
zone and date is displayed
when camera is turned on.
Camera settings reset.
Monitor turns off, and the
power-on lamp blinks
rapidly.
F8
Cause/Solution
• Camera is off.
• Standby mode for saving power: press the
power switch, shutter-release button, c
button, or b (e movie-record) button, or
rotate the mode dial.
• When flash lamp blinks, wait until flash has
charged.
• Camera and computer are connected via USB
cable.
• Camera and TV are connected via A/V cable or
HDMI cable.
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• If camera clock has not been set, "Date not set"
indicator blinks during shooting and movie
recording. Images and movies saved before
clock is set are dated "00/00/0000 00:00" or "01/
01/2011 00:00" respectively. Set the correct time
and date from the Time zone and date option
in the setup menu.
• Check camera clock regularly against more
accurate timepieces and reset as required.
Hide info is selected for Photo info.
Select Show info.
Camera clock has not been set.
• The current shooting mode is one that does not
support Print date.
• The date cannot be imprinted on movies.
Clock battery is exhausted; all settings were
restored to their default values.
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
After the lamp blinks for three minutes, the
camera will turn off automatically. Pressing the
power switch also turns off the camera.
A
21
2, 21
56
81, 84
81, E21
94, E64
F6
22, 94,
E61
94, E64
22, 94,
E61
94, E66
–
22, 23
21